CertsTopics Logo

Big Halloween Sale 70% Discount Offer - Ends in 0d 00h 00m 00s - Coupon code: save70

All 200-301 Test Inside Cisco Questions

Page: 37 / 90
Total 1197 questions
Get 200-301 Full Access Download 200-301 PDF

Implementing and Administering Cisco Solutions (200-301 CCNA) v1.1 Questions and Answers

Question 145

Which action must be taken to assign a global unicast IPv6 address on an interface that is derived from the MAC address of that interface?

Options:

A.

configure a stateful DHCPv6 server on the network

B.

enable SLAAC on an interface

C.

disable the EUI-64 bit process

D.

explicitly assign a link-local address

Question 146

What are two reasons for an engineer to configure a floating state route? (Choose two)

Options:

A.

to automatically route traffic on a secondary path when the primary path goes down

B.

to route traffic differently based on the source IP of the packet

C.

to enable fallback static routing when the dynamic routing protocol fails

D.

to support load balancing via static routing

E.

to control the return path of traffic that is sent from the router

Question 147

Refer to the exhibit.

The nip server 192.168.0.3 command has been configured on router 1 to make it an NTP client of router 2. Which command must be configured on router 2 so that it operates in server-only mode and relies only on its internal clock?

Options:

A.

Router2(config)#ntp passive

B.

Router2(config)#ntp server 172.17.0.1

C.

Router2(config)#ntp master 4

D.

Router2(config)#ntp server 192.168.0.2

Question 148

Refer to the exhibit.

A network administrator assumes a task to complete the connectivity between PC A and the File Server. Switch A and Switch B have been partially configured with VLAN 10, 11, 12, and 13. What is the next step in the configuration?

Options:

A.

Add PC A to VLAN 10 and the File Server to VLAN 11 fa VLAN segmentation

B.

Add VLAN 13 to the trunk links on Switch A and Switch B for VLAN propagation

C.

Add a router on a stick between Switch A and Switch B allowing for Inter-VLAN routing.

D.

Add PC A to the same subnet as the Fie Server allowing for intra-VLAN communication.

Page: 37 / 90
Total 1197 questions
Get 200-301 Full Access Download 200-301 PDF