Summer Special - Limited Time 65% Discount Offer - Ends in 0d 00h 00m 00s - Coupon code: top65certs

Sure Pass Exam 300-410 PDF

Page: 38 / 46
Total 615 questions

Implementing Cisco Enterprise Advanced Routing and Services (300-410 ENARSI) Questions and Answers

Question 149

Drag and drop the MPLS VPN device types from me left onto the definitions on the right.

Options:

Question 150

An engineer is trying to copy an IOS file from one router to another router by using TFTP. Which two actions are needed to allow the file to copy? (Choose two.)

Options:

A.

Copy the file to the destination router with the copy tftp: flash: command

B.

Enable the TFTP server on the source router with the tftp-server flash: command

C.

TFTP is not supported in recent IOS versions, so an alternative method must be used

D.

Configure a user on the source router with the username tftp password tftp command

E.

Configure the TFTP authentication on the source router with the tftp-server authentication local command

Question 151

What is the output of the following command:

show ip vrf

Options:

A.

Show's default RD values

B.

Displays IP routing table information associated with a VRF

C.

Show's routing protocol information associated with a VRF.

D.

Displays the ARP table (static and dynamic entries) in the specified VRF

Question 152

An engineer configured a leak-map command to summarize EIGRP routes and advertise specifically loopback 0 with an IP of 10.1.1.1.255.255.255.252 along with the summary route. After finishing configuration, the customer complained not receiving summary route with specific loopback address. Which two configurations will fix it? (Choose two.)

Options:

A.

Configure access-list 1 permit 10.1.1.0.0.0.0.3.

B.

Configure access-list 1 permit 10.1.1.1.0.0.0.252.

C.

Configure access-list 1 and match under route-map Leak-Route.

D.

Configure route-map Leak-Route permit 10 and match access-list 1.

E.

Configure route-map Leak-Route permit 20.

Page: 38 / 46
Total 615 questions