Summer Special - Limited Time 65% Discount Offer - Ends in 0d 00h 00m 00s - Coupon code: top65certs

Download Latest 300-410 Questions

Page: 12 / 46
Total 615 questions

Implementing Cisco Enterprise Advanced Routing and Services (300-410 ENARSI) Questions and Answers

Question 45

:590

Refer to the exhibit The R2 OSPF route 10 2 2 0/24 shows in the R1 EIGRP routing table without route redistribution performed between OSPF and EIGRP routing protocols Which configuration is required on router R2 to resolve the issue?

Options:

A.

passive-interface FastEthernet 0/0 command in OSPF1.

B.

Add the no auto-summary command in EIGRP 100.

C.

Replace the network 10.0.0.0 command with FastEthernet0/0network in EIGRP 100.

D.

Addthe passive-interface FastEthernet 1/0 command in EIGRP 100

Question 46

:577

Refer to the exhibit. R3 is dual-homed to two service providers for traffic redundancy. R3 prefers its outbound traffic via R2. Which set of configurations achieves this goal?

Options:

A.

Option A

B.

Option B

C.

Option C

D.

Option D

Question 47

Refer to the exhibit. A network engineer cannot remote access R3 using Telnet from switch S1. Which action resolves the issue?

Options:

A.

Allow the inbound connection via the exec command on R3.

B.

Add the transport input telnet command on R3.

C.

Allow to use the ssh -I admin 10.0.0.1 command on the switch.

D.

Add the login admin command on the switch.

Question 48

Refer to the exhibit.

An engineer noticed that the router log messages do not have any information about when the event occurred. Which action should the engineer take when enabling service time stamps to improve the logging functionality at a granular level?

Options:

A.

Replace OSPF process 10 on the interfaces with OSPF process 1 and configure an additional router IO with IPv6 address

B.

Replace OSPF process 10 on the interfaces with OSPF process 1. and remove process 10 from the global configuration

C.

Replace OSPF process 10 on the interfaces with OSPF process 1 for the IPv6 address and remove process 10 from the global configuration

D.

Replace OSPF process 10 on the interfaces with OSPF process 1 for the IPv4 address and remove process 10 from the global configuration

Page: 12 / 46
Total 615 questions