CertsTopics Logo

Summer Certification Sale 70% Discount Offer - Ends in 0d 00h 00m 00s - Coupon code: save70

300-410 Reviews Questions

Page: 18 / 48
Total 642 questions
Get 300-410 Full Access Download 300-410 PDF

Implementing Cisco Enterprise Advanced Routing and Services (300-410 ENARSI) Questions and Answers

Question 69

Clients on ALS2 receive IPv4 and IPv6 addresses but clients on ALS1 receive only IPv4 addresses and not IPv6 addresses. Which action on DSW1 allows clients on ALS1 to receive IPv6 addresses?

Options:

A.

Configure DSW1(config-if)#ipv6 helper address 2002:404:404::404:404

B.

Configure DSW1(dhcp-config)#default-router 2002:A04:A01::A04:A01

C.

Configure DSW1(config)#ipv6 route 2002:404:404:404:404/128 FastEthernet1/0

D.

Configure DSW1(config-if)#ipv6 dhcp relay destination 2002:404:404::404:404 GigabitEthernet1/2

E.

Option A

F.

Option B

G.

Option C

Question 70

Refer to the exhibit.

BGP and EIGRP are mutually redistributed on R3, and EIGRP and OSPF are mutually redistributed on R1. Users report packet loss and interruption of service to applications hosted onthe 10.1.1.0724 prefix. An engineer tested the link from R3 to R4 with no packet loss present but has noticed frequent routing changes on R3 when running the debug ip route command. Which action stabilizes the service?

Options:

A.

Tag the 10.1.1.0/24 prefix and deny the prefix from being redistributed into OSPF on R1.

B.

Repeat the test from R4 using ICMP ping on the local 10.1.1.0/24 prefix, and fix any Layer 2 errors on the host or switch side of the subnet.

C.

Place an OSPF distribute-list outbound on R3 to block the 10.1.10/24 prefix from being advertised back to R3.

D.

Reduce frequent OSPF SPF calculations on R3 that cause a high CPU and packet loss on traffic traversing R3.

Question 71

Refer to the exhibit.

The administrator successfully logs into R1 but cannot access privileged mode commands. What should be configured to resolve the issue?

Options:

A.

aaa authorization reverse-access

B.

secret cisco123! at the end of the username command instead of password cisco123!

C.

matching password on vty lines as cisco123!

D.

enable secret or enable password commands to enter into privileged mode

Question 72

When configuring Control Plane Policing on a router to protect it from malicious traffic, an engineer observes that the configured routing protocols start flapping on

that device. Which action in the Control Plane Policy prevents this problem in a production environment while achieving the security objective?

Options:

A.

Set the conform-action and exceed-action to transmit initially to test the ACLs and transmit rates and apply the Control Plane Policy in the output direction

B.

Set the conform-action and exceed-action to transmit initially to test the ACLs and transmit rates and apply the Control Plane Policy in the input direction

C.

Set the conform-action to transmit and exceed-action to drop to test the ACLs and transmit rates and apply the Control Plane Policy m the input direction

D.

Set the conform-action to transmit and exceed-action to drop to test the ACLs and transmit rates and apply the Control Plane Policy m the output direction

Page: 18 / 48
Total 642 questions
Get 300-410 Full Access Download 300-410 PDF