CertsTopics Logo

Summer Special - Limited Time 65% Discount Offer - Ends in 0d 00h 00m 00s - Coupon code: top65certs

300-410 Questions Bank

Page: 17 / 46
Total 615 questions
Get 300-410 Full Access Download 300-410 PDF

Implementing Cisco Enterprise Advanced Routing and Services (300-410 ENARSI) Questions and Answers

Question 65

Refer to the exhibit.

A network is under a cyberattack. A network engineer connected to R1 by SSH and enabled the terminal monitor via SSH session to find the source and destination of the attack. The session was flooded with messages, which made it impossible for the engineer to troubleshoot the issue. Which command resolves this issue on R1?

Options:

A.

no terminal monitor

B.

(config)#terminal no monitor

C.

#terminal no monitor

D.

(config)#no terminal monitor

Question 66

Refer to Exhibit.

Which two configurations allow clients to get dynamic ip addresses assigned?

Options:

A.

Configure access-list 100 permit udp any any eq 61 as the first line

B.

Configure access-list 100 permit udp any any eq 86 as the first line

C.

Configure access-list 100 permit udp any any eq 68 as the first line

D.

Configure access-list 100 permit udp any any eq 69 as the first line

E.

Configure access-list 100 permit udp any any eq 67 as the first line

Question 67

What does IPv6 Source Guard utilize to determine if IPv6 source addresses should be forwarded?

Options:

A.

ACE

B.

ACLS

C.

DHCP

D.

Binding Table

Question 68

Which two components are needed for a service provider to utilize the LVPN MPLS application? (Choose two.)

Options:

A.

The P routers must be configured for MP-iBGP toward the PE routers

B.

The P routers must be configured with RSVP.

C.

The PE routers must be configured for MP-iBGP with other PE routers

D.

The PE routers must be configured for MP-eBGP to connect to CEs

E.

The P and PE routers must be configured with LDP or RSVP

Page: 17 / 46
Total 615 questions
Get 300-410 Full Access Download 300-410 PDF