CCNP Enterprise 300-410 Release Date

If not configured, the operational physical interface is chosen as the router ID even if a loopback is configured.

The loopback with the highest IP address is selected as the router ID.

The MPLS LDP router ID must match the IGP router ID.

The force keyword changes the router ID to the specified address without causing any impact.

It is not supported in hardware when TCAM is programmed

It does not offer protection in environments where IPv6 traffic is tunneled.

It cannot be configured on a switch port interface in the ingress direction

Packets that are dropped by IPv6 RA Guard cannot be spanned

Add the aaa authentication login default none command to the global configuration.

Replace the capital “C” with a lowercase “c” in the aaa authentication login Console local command.

Add the aaa authentication login default group tacacs+ local-case command to the globalconfiguration.

Add the login authentication Console command to the line configuration

fragmentation

COPP

ICMP redirects

ICMP unreachable messages