CertsTopics Logo

Summer Certification Sale 70% Discount Offer - Ends in 0d 00h 00m 00s - Coupon code: save70

CCNP Enterprise 300-410 Exam Dumps

Page: 4 / 48
Total 642 questions
Get 300-410 Full Access Download 300-410 PDF

Implementing Cisco Enterprise Advanced Routing and Services (300-410 ENARSI) Questions and Answers

Question 13

Refer to the exhibit.

After applying IPsec, the engineer observed that the DMVPN tunnel went down, and both

spoke-to-spoke and hub were not establishing. Which two actions resolve the issue? (Choose two.)

Options:

A.

Configure the crypto isakmp key cisco address 192.1.1.1 on R2 and R3

B.

Configure the crypto isakmp key cisco address 0.0.0.0 on R2 and R3.

C.

Change the mode from mode tunnel to mode transport on R3

D.

Change the mode from mode transport to mode tunnel on R2.

E.

Remove the crypto isakmp key cisco address 10.1.1.1 on R2 and R3

Question 14

Refer to the exhibit.

An engineer is trying to block the route to 192.168.2.2 from the routing table by using the

configuration that is shown. The route is still present in the routing table as an OSPF route. Which action blocks the route?

Options:

A.

Use an extended access list instead of a standard access list.

B.

Change sequence 10 in the route-map command from permit to deny.

C.

Use a prefix list instead of an access list in the route map.

D.

Add this statement to the route map: route-map RM-OSPF-DL deny 20.

Question 15

Refer to the exhibit.

A network engineer for AS64512 must remove the inbound and outbound traffic from link A during maintenance without closing the BGP session so that there ............ a backup link over link A toward the ASN. Which BGP configuration on R1 accomplishes this goal?

A)

B)

C)

D)

Options:

A.

Option A

B.

Option B

C.

Option C

D.

Option D

Question 16

Refer to the exhibit.

A router receiving BGP routing updates from multiple neighbors for routers in AS 690. What is the reason that the router still sends traffic that is destined to AS 690 to a neighbor other than 10.222.1.1?

Options:

A.

The local preference value in another neighbor statement is higher than 250.

B.

The local preference value should be set to the same value as the weight in the route map.

C.

The route map is applied in the wrong direction.

D.

The weight value in another neighbor statement is higher than 200.

Page: 4 / 48
Total 642 questions
Get 300-410 Full Access Download 300-410 PDF