Cisco 300-410 Questions Answers

Implementing Cisco Enterprise Advanced Routing and Services (ENARSI) Questions and Answers

Question 49

Refer to the exhibits.

Phase-3 tunnels cannot be established between spoke-to-spoke in DMVPN. Which two

commands are missing? (Choose two.)

The ip nhrp redirect command is missing on the spoke routers.

The ip nhrp shortcut command is missing on the spoke routers.

The ip nhrp redirect commands is missing on the hub router.

The ip nhrp shortcut commands is missing on the hub router.

The ip nhrp map command is missing on the hub router.

Question 50

Refer to the exhibit.

The ACL is placed on the inbound Gigabit 0/1 interface of the router. Host

192.168.10.10cannot SSH to host 192.168.100.10 even though the flow is permitted. Which action

resolves the issue without opening full access to this router?

Move the SSH entry to the beginning of the ACL

Temporarily move the permit ip any any line to the beginning of the ACL to see if the flow works

Temporarily remove the ACL from the interface to see if the flow works

Run the show access-list FILTER command to view if the SSH entry has any hit statistic associated with it

Question 51

Refer to the exhibit.

Which interface configuration must be configured on the spoke A router to enable a dynamic DMVPN tunnel with the spoke B router?

Option A

Option B

Option C

Option D

Question 52

Drag and drop the MPLS terms from the left onto the correct definitions on the right.