Labour Day Special - Limited Time 65% Discount Offer - Ends in 0d 00h 00m 00s - Coupon code: top65certs

CCNP Enterprise Changed 300-410 Questions

Page: 30 / 43
Total 575 questions

Implementing Cisco Enterprise Advanced Routing and Services (ENARSI) Questions and Answers

Question 117

Refer to the exhibit. A network engineer is provisioning end-to-end traffic service for two different enterprise networks with these requirements

  • The OSPF process must differ between customers on HQ and Branch office routers, and adjacencies should come up instantly.
  • The enterprise networks are connected with overlapping networks between HO and a branch office

Which configuration meets the requirements for a customer site?

A

A)

B)

C)

D)

Options:

A.

Option A

B.

Option B

C.

Option C

D.

Option D

Question 118

Refer to the exhibit.

Reachability between servers in a network deployed with DHCPv6 is unstable. Which command must be removed from the configuration to make DHCPv6 function?

Options:

A.

ipv6 dhcp server DHCPPOOL

B.

ipv6 address 2001:0:1:4::/64

C.

ipv6 nd ra suppress

D.

address prefix 2001:0:1:4::/64 lifetime infinite infinite

Question 119

A network administrator cannot connect to a device via SSH. The line vty configuration is as follows:

Which action resolves this issue?

Options:

A.

Increase the session timeout

B.

Change the stopbits to 10.

C.

Configure the transport input SSH

D.

initialize the SSH key

Question 120

Refer to the exhibit.

An engineer must filter incoming EIGRP updates to allow only a set of specific prefixes. The distribute list is tested, and it filters out all routes except network 10.10.10.0/24. How should the engineer temporarily allow all prefixes to be learned by the routers again without adjusting the existing access list?

Options:

A.

A permit 20 statement should be added before completing the ACL with the required prefixes, and then the permit 20 statement can be removed.

B.

A permit any statement should be added before completing the ACL with the required prefixes and then the permit any statement can be removed.

C.

A continue statement should be added within the permit 10 statement before completing the ACL with the required prefixes, and then the continue statement can be removed.

D.

An extended access list must be used instead of a standard access list to accomplish the task

Page: 30 / 43
Total 575 questions