CCNP Data Center 350-601 Release Date

An engineer must configure OSPF routing on Cisco Nexus 9000 Series Switches. The IP subnet of the Eth 1/2 interface for both switches must be advertised via OSPF. However, these interfaces must not establish OSPF adjacency or send routing updates. The current OSPF adjacency over the interface Eth1/1 on SW1 and Eth1/1 on SW2 must remain unaffected. Which configuration must be applied to both Nexus switches to meet these requirements?

Drag and drop the hyperflex characteristics from the left onto the appropriate. HyperFlex Node types on the right. Not all options are used.

An engineer must monitor the traffic from the uplink Ethernet port. The traffic must be sent to an analyzer connected to interface Eth1/5 of the fabric interconnect. Which configuration must be set on the destination interface to meet this requirement?

Refer to the exhibit. The network management system that is located at 192.168.10.10 and port 2000 must receive traps from the Cisco UCS Manager called UCSM. The community name is Cisco123! and the SNMP version must be the most secure.

These two commands have already been configured on Cisco UCSM.

UCS-A# scope monitoring

UCS-A/monitoring # enable snmp

Which command set completes the SNMP configu