CCNP Data Center 350-601 Reddit Questions

 Option D is the correct configuration to enable the Cisco UCS Manager to manage a Cisco UCS C-Series server by using a single cable for management and data traffic. The commands enter the server scope, then the cimc scope, then the mgmt-conn scope with the sideband option, which enables the management connection through the sideband interface. Then, the mgmt-conn-state is set to enabled and the changes are committed to the buffer. References:

• Cisco UCS Manager CLI Configuration Guide, Release 4.0 - Configuring Cisco UCS C-Series Servers [Cisco UCS Manager], Configuring Cisco UCS C-Series Servers, Configuring the Management Connection
• Cisco UCS Manager CLI Configuration Guide, Release 4.0 - Configuring Cisco UCS C-Series Servers [Cisco UCS Manager], Configuring Cisco UCS C-Series Servers, Enabling the Management Connection Through the Sideband Interface

 The vHBA policy in Cisco UCS Manager is used to specify the WWPN of the storage array and can be configured for zoning type as single initiator multiple targets. The Fibre Channel adapter policy is used to configure interrupt handling and queues of the vHBA interface, which are essential for SAN connectivity.

References: = For more detailed information, refer to the Cisco UCS Manager GUI Configuration Guide and the Cisco Data Center Core Technologies study materials

To install the “Markdown” package from the Python package manager on a Cisco Nexus 93108 Series Switch, the engineer must ensure that the guest shell has internet access to reach the Python package repository. This is achieved by adding the nameserver configuration to /etc/resolv.conf, which allows the system to resolve domain names into IP addresses. After configuring the nameserver, the engineer must run the command sudo chvrf management pip install Markdown to install the package within the management Virtual Routing and Forwarding (VRF) context, which has access to the internet.

References: = For more information on managing packages in the guest shell of Cisco Nexus switches, refer to the Cisco Nexus 9000 Series NX-OS Programmability Guide.

The command in Option D correctly uses a loop to iterate over the range {1…5}, which represents the first five interfaces. The dohost command is used to send commands to the host Cisco Nexus switch from the Guest Shell. The syntax interface eth1/$x and description Server$x within the loop sets the description for each interface eth1/1 to eth1/5 to “Server1” to “Server5” respectively.

Here’s the command from Option D formatted for clarity:

[guestshell@guestshell ~]$ for x in {1..5}; do

dohost "conf t" ;

interface eth1/$x;

description Server$x;

done

This command will configure the description for each of the first five Ethernet interfaces with the respective server number as part of the description.