Summer Special - Limited Time 65% Discount Offer - Ends in 0d 00h 00m 00s - Coupon code: top65certs

All 350-601 Test Inside Cisco Questions

Page: 7 / 14
Total 190 questions

Implementing Cisco Data Center Core Technologies (350-601 DCCOR) Questions and Answers

Question 25

A storage engineer must configure Cisco TrustSec Fibre Channel by using manual ESP mode on a Cisco MDS 9000 Series Switch. ESP mode must use the default message authentication and encryption method. Which configuration must the engineer apply on the switch to complete the configuration?

Options:

A.

Option A

B.

Option B

C.

Option C

D.

Option D

Question 26

An engineer must optimize ARP responses and reduce unnecessary ARP broadcasts over the VXLAN/EVPN fabric. Which action accomplishes these tasks?

Options:

A.

Configure ip proxy-arp under the VLAN SVI associated with the VXLAN VNI.

B.

Configure ip proxy-arp within the VXLAN VNI configuration under the VTEP NVE interface.

C.

Configure suppress-arp within the VXLAN VNI configuration under the VTEP NVE interface

D.

Configure suppress-arp under the VLAN SVI associated with the VXLAN VNI.

Question 27

Refer to the exhibit. An engineer must configure infrastructure monitoring in a Cisco UCS domain to monitor traffic on the Cisco fabric interconnect A and Cisco fabric interconnect B port links connected to Cisco MDS switches SW1 and SW2. The monitored traffic must be sent to Cisco Intersight at 20 Gbps for further analysis. Which command must be run on a UCS device after the create eth-mon-eession EthMonitor1/0 command is run?

Options:

A.

set direction transmit

B.

create fc-mon-session storage

C.

set speed 20gbps

D.

create dest-interface 1 1

Question 28

Which protocol is used by a Cisco NX-OS device to send telemetry data encoded in JSON?

Options:

A.

HTTP

B.

SSH

C.

TCP

D.

RCP

Page: 7 / 14
Total 190 questions