Leadership in Energy and Environmental Design (LEED) Changed LEED-AP-BD+C Questions

The correct answer is A, site conditions. According to theLEED V5: Building Design + Construction Guide, the Integrative Process Prerequisite, Integrative Project Planning and Design, requires the project team to perform a preliminary “simple box” energy modeling and analysis before the completion of schematic design. The purpose of this analysis is to evaluate the energy performance goals of the project and to identify and compare the energy-related design strategies.The analysis should include the following aspects1:

Site conditions, such as climate, solar orientation, shading, and natural ventilation potential

Massing and orientation, such as building shape, size, and orientation, and how they affect the heating and cooling loads, daylight availability, and passive design strategies

Basic envelope attributes, such as insulation levels, window-to-wall ratio, glazing properties, infiltration rates, and thermal bridging

Lighting levels, such as the target illumination levels, daylighting potential, and lighting power density

Plug and process loads, such as the equipment and appliances that consume electricity, and their schedules and controls

Programmatic and operational parameters, such as the occupancy, operating hours, and zoning of the building

Thermal comfort ranges, such as the acceptable temperature and humidity levels for the occupants

HVAC system selection, such as the type, efficiency, and control of the heating, ventilation, and air conditioning system

The other choices are not aspects that should be analyzed when pursuing an integrative design process focusing on energy-related systems, because:

Potable water availability is related to the water efficiency and water quality goals of the project, not the energy performance goals2.

Acoustic performance of the project is related to the indoor environmental quality and occupant comfort goals of the project, not the energyperformance goals3.

Applicability of green vehicles to the project is related to the location and transportation and greenhouse gas emissions goals of the project, not the energy performance goals4.

LEED V5: Building Design + Construction Guide, Integrative Process Prerequisite, Integrative Project Planning and Design, Option 1.Energy-Related Systems1;LEED V5: Building Design + Construction Guide, Water Efficiency Prerequisite, Indoor Water Use Reduction, Requirements2;LEED V5: Building Design + Construction Guide, Indoor Environmental Quality Prerequisite, Minimum Indoor Air Quality Performance, Requirements3;LEED V5: Building Design + Construction Guide, Location and Transportation Credit, Green Vehicles, Requirements4

This option requires the project to increase the breathing zone outdoor airflow by at least 20% above the minimum rates required by ASHRAE 62.1-2010. Therefore, the minimum design zone outdoor airflow is 0.120 CFM/ft2 x 1.2 = 0.144 CFM/ft2.

For the small commercial building described, the applicable requirement is whole-building energy-use monitoring for each energy source at least monthly. This establishes a basic record of electricity, natural gas, district energy, fuel oil, or other energy supplied to the building. Fifteen-minute electricity monitoring represents a much more granular interval and is not the stated minimum for this building-size condition. End-use submetering separately measures categories such as lighting, HVAC, plug loads, and service water heating and is generally associated with more extensive monitoring provisions rather than the basic small-building requirement presented here. Monthly whole-building data enables owners to benchmark performance, identify abnormal changes, compare actual use with forecasts, and support ongoing energy-management activities. Therefore, Option C correctly describes the required monitoring level.

================