Ace Your 350-701 CCNP Security Exam

The debug crypto isakmp sa command shows the status of the Internet Security Association and Key Management Protocol (ISAKMP) security associations (SAs). The output of this command indicates that the ISAKMP negotiation failed after several retransmissions. The most likely cause of this failure is a mismatch in the authentication key between the two peers. The authentication key is specified by the crypto isakmp key command and must be the same on both routers. If the authentication key is different, the ISAKMP messages cannot be decrypted and verified by the peers, resulting in an error. To fix this problem, the network administrator should verify and correct the authentication key on both routers and clear the existing ISAKMP SAs with the clear crypto isakmp sa command. References: 1, 2, 3, 4

Time synchronization is one of the features that can be configured for managed devices in the device platform settings of the Firepower Management Center (FMC). Time synchronization ensures that the FMC and its managed devices have the same date and time settings, which is important for accurate event logging and reporting. The FMC can act as a Network Time Protocol (NTP) server for its managed devices, or it can use an external NTP server as a time source1. The FMC can also synchronize its time with the system clock of the device where it is installed2. References := 1: Firepower Management Center Device Configuration Guide, 7.1 - Platform Settings 2: Firepower Management Center Configuration Guide, Version 6.6 - Device Management Basics

 Suppression is a feature of Cisco Next Generation Intrusion Prevention System (NGIPS) that allows you to reduce false positives and unwanted alerts by filtering out specific traffic from the intrusion detection and prevention process. You can configure suppression based on different criteria, such as port, rule, source, destination, and network. The two valid suppression types for this question are port and rule. Port suppression allows you to exclude traffic based on the source or destination port number, or both. For example, you can suppress alerts for port 80 (HTTP) traffic if you are not interested in web-based attacks. Rule suppression allows you to exclude traffic based on the rule ID (SID) or the rule category. For example, you can suppress alerts for rules that belong to the policy-violations category if you are not concerned about them. You can also suppress alerts for specific rules that are not relevant to your network or generate too many false positives. References

In order to send web traffic transparently to the Web Security Appliance (WSA), the system administrator can use one of these two methods:

• Policy-based routing (PBR) on the network infrastructure: This method allows the administrator to define routing policies based on the source or destination IP address, port number, protocol, or other criteria of the web traffic. The administrator can then apply these policies to the network interfaces or subinterfaces and redirect the matching traffic to the WSA. This method does not require any configuration on the client side and can be applied to any type of web traffic, including HTTPS and FTP. However, this method may require additional network resources and maintenance, as well as coordination with other network administrators.
• Web Cache Communication Protocol (WCCP) on the WSA and the network device: This method allows the administrator to configure the WSA and the network device (such as a router, switch, or firewall) to communicate with each other using WCCP, a Cisco proprietary protocol. The network device acts as a WCCP router and redirects the web traffic to the WSA, which acts as a WCCP client. The WSA then processes the traffic and returns it to the network device, which forwards it to the original destination. This method does not require any configuration on the client side and can be applied to HTTP, HTTPS, and native FTP traffic. However, this method requires that the network device supports WCCP and that the WSA and the network device are in the same Layer 2 domain.

References: