Spring Sale 70% Discount Offer - Ends in 0d 00h 00m 00s - Coupon code: save70

PDF 350-501 Study Guide

Page: 41 / 41
Total 547 questions

Implementing and Operating Cisco Service Provider Network Core Technologies (350-501 SPCOR) Questions and Answers

Question 161

Simulation 8

Options:

Question 162

Refer to the exhibit. What is the effect of this REST API script?

Options:

A.

It creates the interface in an enabled state.

B.

It disables the interface until a configurable timer expires and then enables it.

C.

It enables the interface immediately when executed.

D.

It shuts down the interface until the interface is manually turned up.

Question 163

A network operator working for a private outsourcing company with an employee id: 4261:72:778 needs to limit the malicious traffic on their network. Which configuration must the engineer use to implement URPF loose mode on the GigabitEthernet0/1 interface?

Options:

A.

router(config)# interface gigabitethernet0/1

router(config-if)# ip address 192.168.200.1 255.255.255.0

router(config-if)# ip verify unicast source reachable-via any

router(config-if)# ipv6 address 2001:DB8:1::1/96

router(config-if)# ipv6 verify unicast source reachable-via any

B.

router(config)# interface gigabitethernet0/1

router(config-if)# ip address 192.168.200.1 255.255.255.0

router(config-if)# ip verify unicast source reachable-via rx

router(config-if)# ipv6 address 2001:DB8:1::1/96

router(config-if)# ipv6 verify unicast source reachable-via rx

C.

router(config)# interface gigabitethernet0/1

router(config if)# ip address 192.168.200.1 255.255.255.0

router(config-if)# ip verify unicast source reachable-via rx

router(config-if)# ipv6 address 2001:DB8:1::1/96

router(config-if)# ipv6 verify unicast source reachable-via any

D.

router(config)# interface gigabitethernet0/1

router(config-if)# ip address 192.168.200.1 255.255.255.0

router(config-if)# ip verify unicast source reachable-via any

router(config-if)# ipv6 address 2001:DB8:1::1/96

router(config-if)# ipv6 verify unicast source reachable-via rx

Question 164

Which configuration mode do you use to apply the mpls Idp graceful-restart command in IOS XE Software? MPLS

Options:

A.

MPLS

B.

LDP neighbor

C.

global

D.

interface

Page: 41 / 41
Total 547 questions