CCNP Service Provider 350-501 Dumps PDF

Implementing and Operating Cisco Service Provider Network Core Technologies (SPCOR) Questions and Answers

Question 13

A network engineer must configure a router for Flexible NetFlow IPFIX export. The IP address of the destination server is 172.17.12.1. The source address must be set to the Loopback0 IPv4 address and exported packets must be set to DSCP CS3. The TTL must be 64 and the transport protocol must be set to UDP with destination port 4739. Which configuration must the engineer apply to the router?

Options:

configure terminal

flow exporter EXPORTER-1

destination 172.17.12.1

source Loopback0

dscp 3

ttl 64

export-protocol netflow-v9

transport udp 4739

end

configure terminal

flow exporter EXPORTER-1

destination 172.17.12.1

source Loopback0

dscp 24

ttl 64

export-protocol ipfix

end

configure terminal

flow exporter EXPORTER-1

destination 172.17.12.1

source Loopback0

dscp 24

ttl 64

export-protocol netflow-v9

transport udp 4739

end

configure terminal

flow exporter EXPORTER-1

destination 172.17.12.1

source Loopback0

dscp 3

ttl 64

export-protocol ipfix

end

Question 14

Refer to the exhibit:

What does the REST API command do?

Options:

It retrieves the information requested by Descriptions xml

It removes the information identified by Descriptions xml

It executes the commands specified in Descriptions xml

It displays the information identified by Descriptions xml

Question 15

You are creating new Cisco MPLS TE tunnels. Which type of RSVP message does the headend router send to reserve bandwidth on the path to the tunnel’s router?

Options:

error

reservation

path

tear

Question 16

Refer to the exhibit.

A network engineer at a large ISP Is configuring telemetry streams to monitor the health status of PE routers on the network using gRPC dial-out. The PE routers are located at several data centers in different physical locations, and they are using IS-IS and BGP for routing. Which additional configuration must the engineer implement on the PE routers to meet the goal?