Linux+ XK0-005 Dumps PDF

The file /etc/ssh/sshd_config contains the configuration settings for the SSH daemon, which handles the secure remote login. To change the port number, the engineer should edit this file and modify the line that says Port 22 to Port 49000. The other files are not related to the SSH service. References: CompTIA Linux+ (XK0-005) Certification Study Guide, Chapter 13: Managing Network Services, page 411.

The command iptables -t nat -A PREROUTING -p tcp --dport 80 -j DNAT --to-destination 192.0.2.25:3128 adds a rule to the nat table that redirects all incoming TCP packets with destination port 80 (HTTP) to the proxy server 192.0.2.25 on port 3128. This is the correct way to achieve the task. The other options are incorrect because they either delete a rule (-D), use the wrong protocol (top instead of tcp), or use the wrong port (81 instead of 80). References: CompTIA Linux+ (XK0-005) Certification Study Guide, Chapter 12: Managing Network Connections, page 381.

The command that can be used to remove an RPM package that was installed by mistake is dnf remove packagename. This command will use the DNF package manager to uninstall an RPM package and its dependencies from a Linux system that uses RPM-based distributions, such as Red Hat Enterprise Linux or CentOS. The DNF package manager handles dependency resolution and metadata searching for RPM packages.

The other options are not correct commands for removing an RPM package from a Linux system. The apt-get remove packagename and apt remove packagename commands are used to remove Debian packages from a Linux system that uses Debian-based distributions, such as Ubuntu or Debian. They are not compatible with RPM packages. The rpm -i packagename command is used to install an RPM package, not to remove it. References: CompTIA Linux+ (XK0-005) Certification Study Guide, Chapter 9: Managing Software Packages; How to install/remove/query/update RPM packages in Linux (Cheat Sheet …

The command that will help the administrator install GRUB on the legacy MBR of the SATA hard drive is grub-install /dev/sda. This command will install GRUB on the master boot record (MBR) of the first SATA disk (/dev/sda). The MBR is the first sector of a disk that contains boot code and a partition table. GRUB will overwrite the boot code and place its own code that can load GRUB modules and configuration files from a specific partition.

The other options are not correct commands for installing GRUB on the legacy MBR of the SATA hard drive. The grub-install /dev/hda command will try to install GRUB on the first IDE disk (/dev/hda), which may not exist or may not be bootable. The grub-install /dev/sr0 command will try to install GRUB on the first SCSI CD-ROM device (/dev/sr0), which is not a hard drive and may not be bootable. The grub-install /dev/hd0,0 command is invalid because grub-install does not accept partition names as arguments, only disk names. References: Installing GRUB using grub-install; GRUB Manual