CompTIA 220-1201 Questions Answers

RAID 1, also known as disk mirroring, duplicates data identically to two drives, ensuring full redundancy if one drive fails. Because the workstation only has two drives, RAID 1 is the only RAID level that provides fault tolerance under this constraint, exactly as described in the CompTIA A+ study guide.

RAID 0 offers no redundancy, RAID 5 requires at least three drives, and RAID 10 requires at least four drives.

RAID 1 is the recommended configuration for small environments or workstations that rely on data integrity and quick recovery, matching CompTIA’s guidance for redundancy in systems with limited drive availability.

When a laptop screen is replaced, the technician typically removes the display bezel and may disconnect cables routed through the hinge area. The Wi-Fi antennas in most laptops are mounted inside the display assembly (often along the top edges of the screen) and their thin coax antenna leads run through the hinges to the wireless adapter connection points on the system board or directly onto the Wi-Fi card (MAIN/AUX terminals). If one or both antenna leads are left unplugged, pinched, or poorly seated during reassembly, the laptop will still detect the Wi-Fi adapter, but wireless performance will be severely degraded—weak signal strength, intermittent connections, inability to see networks reliably, or frequent dropouts.

This symptom appearing immediately after a screen replacement strongly indicates a physical antenna connection issue rather than a driver or software problem. Reinstalling drivers or resetting services would be more appropriate after OS changes or configuration corruption, not after display hardware work. Compatibility of wireless technologies is unrelated to swapping a screen. Therefore, the best CompTIA A+ troubleshooting step is to open the unit and reconnect/secure the Wi-Fi antenna leads to the system board/wireless card.

RG11 coaxial cable with quad shielding is designed to handle large volumes of internet traffic, providing excellent resistance to interference and high bandwidth capacity.

Why Not A (USB 3.1): USB 3.1 is used for connecting peripherals, not for high-volume internet traffic.

Why Not C (SATA3.0): SATA is used for internal data storage connections, not for network traffic.

Why Not D (Unshielded plenum RJ45): While RJ45 cables are commonly used, unshielded cables are prone to interference and are not ideal for high-volume traffic.

CompTIA A+ Exam Reference: Core 1 (220-1201), Section 3.1, cable types and their characteristics​.

An automatic document feeder (ADF) is designed to speed up scanning jobs that involve many pages by feeding sheets through the scanner automatically, one after another, without requiring the user to lift the lid and position each page manually. For a 300-page contract, the biggest time loss is the manual handling of every page on a flatbed. With an ADF-equipped scanner or multifunction printer, the user can load a stack of pages into the feeder tray and the device will process them continuously, greatly improving productivity and reducing user effort. This is a common CompTIA A+ Core 1 concept when comparing scanner hardware features and selecting the correct device for high-volume tasks.

A flatbed scanner (A) is typically slower for large documents because it requires manual placement of each page. Duplexing (B) can be helpful when scanning double-sided documents because it captures both sides automatically, but it does not address the “each page must be scanned individually” issue as effectively as an ADF does for high page counts. Orientation configuration (D) only changes how pages are rotated or aligned in the output file and does not increase scan throughput. Therefore, an ADF is the best choice to increase scanning speed for a large contract.