A+ 220-1201 Reddit Questions

When troubleshooting intermittent latency to a remote internal resource, CompTIA A+ recommends using tools that help identify where latency occurs and whether it is consistent or fluctuating over time. The best tools for this scenario are ping -t and tracert.

Ping -t (B) sends continuous ICMP echo requests, allowing the technician to observe packet loss, fluctuating response times, or timeouts. This helps identify intermittent connectivity problems that occur at specific times, such as bandwidth congestion, routing instability, or wireless interference.

Tracert (F) maps each hop between the local workstation and the remote office. If latency spikes occur only after a particular hop—such as a VPN tunnel, MPLS gateway, or inter-office router—that device becomes the suspected bottleneck. This makes tracert essential for isolating WAN-related slowdowns.

Ipconfig /all (A) only provides local configuration and does not diagnose latency. Nslookup (C) is for DNS testing—not latency to a specific internal host. Examining switchports (D) helps with local issues but not remote latency. QoS (E) is a solution, not a troubleshooting step. Calling ISP (G) may be premature unless testing confirms ISP-related issues.

Thus, ping -t and tracert are the correct diagnostic tools.

When a newly built workstation shows no response at all—no fans spinning, no indicator LEDs, and no POST activity—this indicates that the system is not receiving the signal to power on. Since the technician has already verified that all primary power connectors are fully seated (including the 24-pin ATX motherboard connector and the 4-pin or 8-pin CPU power connector), the most likely cause is that the case header pins are not connected to the motherboard.

According to CompTIA Core 1 (220-1201) hardware installation and troubleshooting concepts, the power button on the computer case connects to the motherboard via the front-panel (system panel) header, specifically the PWR_SW pins. If this connector is missing, improperly placed, or connected to the wrong pins, pressing the power button will do nothing because the motherboard never receives the power-on signal.

Incorrectly seated RAM typically allows the system to power on but prevents successful POST, often resulting in beep codes or error lights. An underpowered PSU usually causes instability, random shutdowns, or failure under load rather than complete inactivity. A faulty CPU fan connector generally triggers a BIOS warning or shutdown after power-on, not total failure to start.

This scenario directly matches CompTIA’s emphasis on checking front-panel connections as a primary step when a system does not power on at all.

The 12VHPWR connector can supply up to 600 watts of power, designed for high-end graphics cards.

Why Not A (400W): This is less than the connector’s maximum capability.

Why Not B (MOW): This is an invalid option.

Why Not D (700W): The maximum supported power is 600W.

CompTIA A+ Exam Reference: Core 1 (220-1201), Section 3.4, power supply and connectors​.

A managed switch provides advanced features such as traffic monitoring and VLAN configuration, allowing a technician to view network statistics for devices on the local subnet.

Why Not B (Router): A router connects different networks and directs traffic between them but does not provide detailed subnet-level statistics.

Why Not C (Access point): Access points provide wireless connectivity but lack traffic monitoring features.

Why Not D (Firewall): A firewall filters traffic but is not used for monitoring detailed statistics on a local subnet.

CompTIA A+ Exam Reference: Core 1 (220-1201), Section 2.6, network monitoring tools​.