Complete 300-710 Cisco Materials

In a passive IPS deployment for a Cisco Secure Firewall Threat Defense (FTD) device, the administrator must configure the interface to operate in passive mode. This involves setting the interface mode, associating it with a security zone, enabling the interface, and setting the MTU parameter.

Steps:

Set the interface mode to passive:

In FMC, navigate toDevices > Device Management.

Select the FTD device and configure the relevant interface.

Set the interface mode to " Passive. "

Associate the interface with a security zone:

Create or select an appropriate security zone.

Assign the passive interface to this security zone.

Enable the interface:

Ensure the interface is enabled to receive traffic.

Set the MTU parameter:

Configure the Maximum Transmission Unit (MTU) parameter as required.

This ensures that the FTD device can inspect traffic passively without impacting the network flow.

Reason: the command " capture-traffic " is used for SNORT Engine Captures. To capture a LINA Engine Capture, you use the " capture " command. Since the Lina Engine represents the actual physical interface of the device, " capture " is the only reasonable choice

The command is

firepower# capture DMZ interface dmz trace detail match ip host 192.168.76.14 host 192.168.76.100

firepower# capture INSIDE interface inside trace detail match ip host 192.168.76.14 host 192.168.75.14