Big Cyber Monday Sale 70% Discount Offer - Ends in 0d 00h 00m 00s - Coupon code: save70

CCNP Security 300-710 Dumps PDF

Page: 26 / 29
Total 385 questions

Securing Networks with Cisco Firepower (300-710 SNCF) Questions and Answers

Question 101

An engineer is integrating Cisco Secure Endpoint with Cisco Secure Firewall Management Center in high availability mode. Malware events detected by Secure Endpoint must also be

received by Secure Firewall Management Center and public cloud services are used. Which two configurations must be selected on both high availability peers independently? (Choose two.)

Options:

A.

internet connection

B.

Smart Software Manager Satellite

C.

Cisco Success Network

D.

security group tag

E.

Secure Endpoint Cloud Connection

Question 102

Upon detecting a flagrant threat on an endpoint, which two technologies instruct Cisco Identity Services Engine to contain the infected endpoint either manually or automatically? (Choose two.)

Options:

A.

Cisco ASA 5500 Series

B.

Cisco FMC

C.

Cisco AMP

D.

Cisco Stealthwatch

E.

Cisco ASR 7200 Series

Question 103

An engineer currently has a Cisco FTD device registered to the Cisco FMC and is assigned the address of 10 10.50.12. The organization is upgrading the addressing schemes and there is a requirement to convert the addresses to a format that provides an adequate amount of addresses on the network What should the engineer do to ensure that the new addressing takes effect and can be used for the Cisco FTD to Cisco FMC connection?

Options:

A.

Delete and reregister the device to Cisco FMC

B.

Update the IP addresses from IFV4 to IPv6 without deleting the device from Cisco FMC

C.

Format and reregister the device to Cisco FMC.

D.

Cisco FMC does not support devices that use IPv4 IP addresses.

Question 104

An engineer must investigate a connectivity issue and decides to use the packet capture feature on Cisco FTD. The goal is to see the real packet going through the Cisco FTD device and see the Snort detection actions as a part of the output. After the capture-traffic command is issued, only the packets are displayed. Which action resolves this issue?

Options:

A.

Use the verbose option as a part of the capture-traffic command

B.

Use the capture command and specify the trace option to get the required information.

C.

Specify the trace using the -T option after the capture-traffic command.

D.

Perform the trace within the Cisco FMC GUI instead of the Cisco FTD CLI.

Page: 26 / 29
Total 385 questions