Vce 400-007 Questions Latest

OSPF throttling timers control the pacing and frequency of SPF calculations and LSA generation. They help strike a balance between fast convergence and control-plane stability. The key timers include:

LSA generation throttling (min/max interval between LSA originations)

SPF calculation throttling (delays between consecutive SPF runs)

By tuning these timers, network designers can:

Prevent CPU overload caused by rapid or repeated LSA updates due to flapping links

Smooth out instability while still enabling responsive convergence

This approach aligns with CCDE v3.1 under “Protocol Design Implications” for optimizing IGP behavior in large, dynamic topologies.

==========

In this scenario, the application itself duplicates data transmission across two separate NICs on Host A, with the intention that at least one copy will reach Host B, regardless of any single path or link failure. While this increases redundancy at the application and host level, the underlying network must also support rapid failure recovery to avoid packet loss during convergence events.

Among the options provided:

A. EIGRP with feasible successors provides pre-computed backup routes but still requires routing protocol convergence upon failure, which could result in millisecond-scale interruption—enough to cause data loss if packets are in transit.

B. BFD (Bidirectional Forwarding Detection) offers rapid detection of link failures, but by itself does not provide traffic redirection or packet protection; it simply informs the routing protocol faster.

D. Static routes lack dynamic convergence capabilities and would not offer high availability across dynamic failure points unless manually configured with tracking—still less responsive and scalable.

C. IP Fast Reroute (IP FRR) is specifically designed to offer sub-50ms convergence time by pre-installing backup paths in the forwarding plane. Upon detecting a failure, traffic is immediately switched to the pre-computed alternate path without waiting for the routing protocol to reconverge. This ensures minimal disruption and best supports lossless delivery for high-availability applications.

IP FRR is consistent with CCDE v3.1 design principles where sub-second convergence and resiliency are critical in mission-critical enterprise and data center architectures.

C (Layer 2 switches unaffected):IPv6 operates at Layer 3, so pure Layer 2 switches forward frames without needing IPv6 awareness. As long as switches can transparently forward Ethernet frames, IPv6 functionality will be preserved, minimizing unnecessary hardware upgrades.

Other options explained:

A/B/D: These unnecessarily increase cost and complexity for basic Layer 2 functionality where IPv6 awareness is not mandatory.