Last Attempt 156-315.81 Questions

 When SecureXL is enabled, all packets should be accelerated, except packets that match the following conditions: CIFS packets. SecureXL is a technology that accelerates network traffic processing by offloading intensive operations from the Firewall kernel to a dedicated SecureXL device. However, some packets cannot be accelerated by SecureXL due to various reasons, such as unsupported features, security policy settings, or protocol limitations. One example of packets that cannot be accelerated by SecureXL are CIFS packets, which are used for file sharing and access over SMB protocol. CIFS packets are not accelerated by SecureXL because they require stateful inspection by the Firewall kernel. 

The valid range for VRID value in VRRP configuration is 1 - 255. VRID stands for Virtual Router ID, and it is a number that identifies a virtual router in a VRRP cluster. A VRRP cluster consists of one or more routers that share a virtual IP address and provide redundancy and load balancing for network traffic. Each router in the cluster must have a unique VRID value, and the VRID value must match the VRID value configured on the interface that connects to the VRRP cluster. The VRID value can be any number from 1 to 255, inclusive. 

The tool that is used to enable ClusterXL is cpconfig. ClusterXL is a software-based Load Sharing and High Availability solution that distributes network traffic between clusters of redundant Security Gateways1. ClusterXL can be enabled on Check Point Security Gateways running on Gaia OS, SecurePlatform OS, IPSO OS, or X-Series XOS2.

To enable ClusterXL, the administrator must run the cpconfig command on each cluster member and select the option to enable ClusterXL. This will prompt the administrator to choose the ClusterXL mode (High Availability or Load Sharing) and the Cluster Control Protocol (CCP) mode (Broadcast or Multicast). After enabling ClusterXL, the administrator must reboot the cluster members for the changes to take effect34.

Therefore, the correct answer is B. The tool that is used to enable ClusterXL is cpconfig.

References:

• 1, Introduction to ClusterXL - Check Point Software
• 2, ClusterXL Requirements and Compatibility - Check Point Software
• 3, Configuring ClusterXL - Check Point Software
• 4, How to configure ClusterXL - Check Point Software Technologies

According to the Check Point Resource Library, the minimum amount of RAM needed for a Threat Prevention Appliance is 4 GB. This applies to both physical and virtual appliances. The other options are either incorrect or irrelevant. References: Check Point Resource Library