Fortinet FCP_FGT_AD-7.4 Exam With Confidence Using Practice Dumps

With the override setting enabled and a higher priority configured on FGT-2, it will preempt FGT-1 and become the primary unit in the HA cluster.

A- The debug flow is for ICMP traffic.

B. A firewall policy allowed the connection.

C. A new traffic session was created.

D. The default route is required to receive a reply.

The debug flow is for ICMP traffic.

The output shows "proto=1," which indicates that the protocol is ICMP (Internet Control Message Protocol).

A new traffic session was created.

The message "allocate a new session-00003dd5" confirms that a new session was created for this traffic.

The routing table in the exhibit shows two default routes (0.0.0.0/0) with different administrative distances:

The default route through port2 has an administrative distance of 20.

The default route through port1 has an administrative distance of 10.

Administrative distance determines the priority of the route; a lower value is preferred. Here, the route through port1 with an administrative distance of 10 is the preferred route. The route through port2 with an administrative distance of 20 acts as a standby or backup route. If the primary route (port1) fails or is unavailable, traffic will then be routed through port2.

Regarding the statement that the port2 interface is marked as inactive, there is no indication in the routing table that port2 is inactive. Similarly, all the routes displayed are not necessarily installed in the FortiGate routing table, as the table could include both active and backup routes.

References:

FortiOS 7.4.1 Administration Guide: Default route configuration

FortiOS 7.4.1 Administration Guide: Routing table explanation