Cisco 350-701 Exam With Confidence Using Practice Dumps

Explanation

The command “snmp-server user user-name group-name [remote ip-address [udp-port port]] {v1 | v2c | v3 [encrypted] [auth {md5 | sha} auth-password]} [access access-list]” adds a new user (in this case “andy”) to an SNMPv3 group (in this case group name “myv3”) and configures a password for the user.

In the “snmp-server host” command, we need to:

+ Specify the SNMP version with key word “version {1 | 2 | 3}”

+ Specify the username (“andy”), not group name (“myv3”).

Note: In “snmp-server host inside …” command, “inside” is the interface name of the ASA interface through which the NMS (located at 10.255.254.1) can be reached.

Posture is a service in Cisco ISE that allows you to check the compliance, also known as posture, of endpoints, before allowing them to connect to your network. A posture agent, such as the AnyConnect ISE Posture Agent or Network Admission Control (NAC) Agent, runs on the endpoint and collects information about the endpoint’s security posture, such as antivirus, antispyware, firewall, and patch status. The posture agent then communicates with the ISE server, which evaluates the posture information against the posture policy and determines the compliance state of the endpoint. Based on the compliance state, the ISE server can grant or deny network access to the endpoint, or apply remediation actions to bring the endpoint into compliance. Posture service is part of the ISE solution for network access control (NAC), which aims to secure the network from unauthorized or compromised endpoints. References:

Cisco Identity Services Engine Administrator Guide, Release 2.2 - Configure Client Posture Policies

Configuring posture services with the Cisco Identity Services Engine - Cisco Community

Cisco Content Hub - Configure Client Posture Policies

Explanation

Explanation

Southbound APIs enable SDN controllers to dynamically make changes based on real-time demands and

scalability needs.