Sure Pass Exam CWNA-108 PDF

WLAN bridges must use a channel with acceptable SNR at both transceivers to maintain the desired data rate bi-directionally. A WLAN bridge is a device that connects two or more networks using the 802.11 protocol. A WLAN bridge must have a clear and strong signal between the two endpoints to ensure reliable and fast data transmission. The signal-to-noise ratio (SNR) is a measure of the quality of the signal, which depends on the distance, interference, obstacles, and antenna gain between the transceivers. A higher SNR means a better signal quality and a higher data rate. A lower SNR means a worse signal quality and a lower data rate. Therefore, a WLAN bridge must use a channel with acceptable SNR at both transceivers to maintain the desired data rate bi-directionally1.

An IEEE 802.11 amendment is a proposed change or addition to the existing 802.11 standard, which defines the specifications and protocols for wireless LANs. An amendment goes through several stages of development, such as draft, sponsor ballot, and final approval, before it is ratified by the IEEE Standards Association and becomes part of the standard. Until then, it has no official impact on the standard, although some vendors may release products based on draft amendments to gain a competitive edge or to influence the final outcome of the amendment . References: [CWNA-109 Study Guide], Chapter 1: Overview of Wireless Standards, Organizations, and Fundamentals, page 25; [CWNA-108 Study Guide], Chapter 1: Overview of Wireless Standards, Organizations, and Fundamentals, page 23; [IEEE website], IEEE-SA Standards Development Process.

The error in administration that could be the cause of this security concern is that HTTP is in use instead of HTTPS. HTTP is an unencrypted protocol that transfers data in plain text over the network. This means that anyone who captures the traffic can see the HTML code of the Web pages used for access point management, as well as any sensitive information such as passwords or configuration settings. HTTPS is an encrypted protocol that uses SSL/TLS to secure the data transmission between the Web browser and the Web server. HTTPS prevents anyone from snooping on or tampering with the Web traffic. Therefore, HTTPS should always be used for Web based management of wireless access points, especially in autonomous mode where there is no centralized controller to enforce security policies. References: [CWNP Certified Wireless Network Administrator Official Study Guide: Exam CWNA-107], page 431; [HTTP vs HTTPS: What’s The Difference And Why Should You Care?].

The guard interval is a short period of time inserted between the symbols of an OFDM signal to prevent inter-symbol interference and improve the robustness of the transmission1. The guard interval can have different values depending on the 802.11 standard and the configuration of the device. For example, 802.11n supports two guard intervals: 800 ns (normal) and 400 ns (short)2. 802.11ac supports the same guard intervals as 802.11n, plus an optional 200 ns guard interval for 80 MHz and 160 MHz channels3. 802.11ax supports three guard intervals: 800 ns, 1600 ns, and 3200 ns4.

The guard interval affects the data rate because it determines the duration of each symbol. A shorter guard interval means more symbols can be transmitted in a given time, resulting in a higher data rate. However, a shorter guard interval also means less protection against inter-symbol interference, which may degrade the signal quality and increase the error rate. Therefore, there is a trade-off between data rate and reliability when choosing the guard interval.

The MCS tables for HT and VHT PHY devices show the data rates for different combinations of modulation, coding, channel width, spatial streams, and guard intervals. For example, for a VHT device using MCS 9 with QAM-256 modulation, 5/6 coding rate, 80 MHz channel width, and one spatial stream, the data rate is 433.3 Mbps with a normal guard interval (800 ns) and 486.7 Mbps with a short guard interval (400 ns)2. Therefore, the guard interval impacts the data rate according to the MCS tables.