VMware 5V0-22.23 Exam With Confidence Using Practice Dumps

To ensure that a single rack failure is not going to affect the data availability, while minimizing the number of racks used, the administrator has to do the following:

• Distribute servers across at least three different racks. This is because vSAN supports up to three fault domains per cluster, which can be used to tolerate one or two failures. If only two racks are used, then only one failure can be tolerated4
• Configure three fault domains. A fault domain is a logical grouping of hosts that share a common failure point, such as a rack or a power supply. By configuring fault domains, vSAN can place replicas of an object across different fault domains, so that a failure within one fault domain does not result in data loss orunavailability4 References: 4: VMware vSAN Specialist v2 Exam Preparation Guide, page 13

To deploy a new two-node vSAN cluster with a shared witness, the administrator must meet several requirements, one of which is that the ESXi hosts must have a minimum of 64 GBs of memory. This is because each host must have enough memory to run the VMs and also to support the vSAN metadata overhead. The other options are not requirements for a two-node vSAN cluster with a shared witness. The ESXi hosts do not need SSDs or NVMe for Virtual Flash File System, as they can use any supported storage devices for vSAN. The ESXi host’s controller cache and advanced features do not need to be disabled, as they can be used to improve performance and reliability. The ESXi host’s drives do not need to be configured in RAID 1, as vSAN uses its own software-defined RAID mechanism to provide Failures to Tolerate. References: Shared Witness for 2-Node vSAN Deployments; Two-Node Cluster Requirements

The reason why the vSAN administrator cannot find any vSAN performance statistics on the cluster summary page is that the vSAN performance service is not enabled. The vSAN performance service is a feature that collects and analyzes performance metrics and displays them in graphical charts in vCenter. The vSAN performance service must be turned on manually for each vSAN cluster, as it is not enabled by default. The other options are not correct. The integration of vRealize Operations Manager with the vSAN cluster is not required to view vSAN performance statistics, as they are available in vCenter. The administrator’s permissions on the cluster level do not affect the visibility of vSAN performance statistics, as they are accessible to any user who can view the cluster. vSAN performance statistics are not only available via CLI, as they can also be viewed in vCenter using the vSAN performance service. References: About the vSAN Performance Service; Enable or Disable the Performance Service