Helping Hand Questions for AZ-220

During the POV phase, you connect a device to IoT Hub and start sending telemetry messages.

You need to verify the content of the messages received by IoT Hub during the POV phase.

What should you use?

You have an Azure loT hub

You have four Azure 10T Edge devices and. The device twin code shown in the following table.

You have three deployments and the deployment code shown in the following table.

For each of the following statements, select Yes if the statement is true. Otherwise, select No. NOTE: Each correct selection is worth one point.

You have an Azure 10T solution that includes an loT device named Device1.

You need to enable an loT Plug and Play app for Device1.

How should you complete the device connection? To answer select the appropriate options m the answer area.

NOTE: Each correct selection is worth one point.

You have an Azure subscription that contains an Azure loT hub named Hubl and an Azure loT Edge device named Devicel.

You need to configure Devicel to operate in extended offline mode and to support modifying the configuration of modules deployed to Device! while the device is offline.

Solution: From Microsoft Visual Studio Code, you modify the deployment manifest and you configure the address of the localhost for the container registry in the runtime settings of edgeAgent. You deploy the manifest to Device1, and then you restart the device.

Does this meet the goal?