Power Up Your Study Prep: Black Friday 75% Discount! Use coupon code below to save! - Ends in 0d 00h 00m 00s - Coupon code: big75certs

Selected NS0-094 NAHSE Questions Answers

Page: 2 / 6
Total 81 questions

NetApp Hardware Support Engineer Professional Exam Questions and Answers

Question 5

You are upgrading your 6-node NetApp ONTAP cluster from ONTAP 9.9.1 to 9.16.1. As part of the ONTAP software upgrade process, you need to update the cluster switches. After you update the first switch, you receive the following AutoSupport message:

Exhibit — AutoSupport Alert

vifmgr: callhome.clus.net.degraded:alert:

Call home for CLUSTER NETWORK DEGRADED:

Large MTU Packet Loss - Ping failures detected

between Node1_clus1 (169.254.2.94) on Node1

and Node2_clus2 (169.254.248.67) on Node2.

All cluster ports and interfaces are in an up/up status.

What is causing this error?

Options:

A.

ONTAP software is not at the same version on all nodes.

B.

The RCF file has not been applied to all switches.

C.

The ONTAP software version is not compatible with some of the controllers.

D.

The cluster switches have different firmware versions.

Question 6

You have replaced the cluster backend switches on a 4-node NetApp ONTAP cluster with new switches. After the replacement, you realize that the system shows errors for the old switches that were removed:

You also notice that system switch ethernet show shows four switches, the two old switches and the two new switches.

What action will resolve the issue?

Options:

A.

Perform a reboot of the affected node using the storage failover takeover command.

B.

Delete the old switches from the database using the system switch ethernet delete command.

C.

Clear the health alert using the system health alert delete command.

D.

Reconnect the old switches and download a support bundle using the system switch ethernet log collect command.

Question 7

Which two commands confirm whether an aggregate is WAFL inconsistent? (Choose two.)

Options:

A.

wafiron show < aggregate >

B.

node run –node < node > sysconfig –r

C.

storage aggregate show

D.

node run –node < node > sysconfig –a

Question 8

When you add a new disk to an ONTAP 9.1 system, you see an error that the disk “has raid label with version (16), which is not within the currently supported range (14-15).” What is one possible cause of this error?

Options:

A.

The disk is a non-zeroed spare.

B.

The disk firmware is too new for ONTAP software.

C.

The disk needs to be assigned to the new system.

D.

The disk was in a system with a newer version of ONTAP software

Page: 2 / 6
Total 81 questions