Power Up Your Study Prep: Black Friday 75% Discount! Use coupon code below to save! - Ends in 0d 00h 00m 00s - Coupon code: big75certs

Pass NS0-094 Exam Guide

Page: 6 / 6
Total 81 questions

NetApp Hardware Support Engineer Professional Exam Questions and Answers

Question 21

A node has panicked with a PCI/NMI error. Giveback has not been performed.

Which two commands should you run to collect the logs to determine the cause? (Choose two.)

Options:

A.

pelog –a –g=2

B.

show pci –v

C.

rdfile /mroot/etc/log/SSRAM

D.

event log show

Question 22

You have replaced a failed boot device. You perform boot_recovery and receive no errors. However, when the node reboots, it reports that it has no disks.

What are two possible causes? (Choose two.)

Options:

A.

The SAS cables were incorrectly reconnected after reinstalling the motherboard.

B.

The disks that are owned by this node have been marked as failed.

C.

The node is booting a lower version of ONTAP software than was last used.

D.

The interconnect is down.

Question 23

You receive the following AutoSupport message:

[Node-01: cshmd: hm.alert.raised:alert]:

Alert Id = ClusterSwitchConnectivity_Alert

Alerting Resource = Node-02

raised by monitor ethernet-switch

[Node-01: mgwd: callhome.hm.alert.major:alert]:

Call home for Health Monitor process cshm:

ClusterSwitchConnectivity_Alert[Node-02].

[Node-01: mgwd: callhome.hm.alert.major:alert]:

Call home for Health Monitor process cshm:

ClusterSwitchConnectivity_Alert[Node-02].

When researching, you discover the following output:

Exhibit 2 — Network Port Health

Cluster::* > network port show

-health-status degraded

-fields health-degraded-reasons

node port health-degraded-reasons

-------- ---- -----------------------

Node-02 e0a link_flapping

What action do you take to resolve this issue?

Options:

A.

Replace the SFP on port e0a on node-02.

B.

Update the RCF file on the cluster switches.

C.

Update the firmware on the cluster switches.

D.

Replace the SFP on port e0a on node-01.

Question 24

A node has failed.

Which two conditions must be met for an automatic takeover to be triggered? (Choose two.)

Options:

A.

The combined utilization of both nodes must be less than 100%.

B.

The cluster network must be available.

C.

Mailbox disks must be reachable.

D.

NVRAM must be synchronized.

Page: 6 / 6
Total 81 questions