Comprehensive and Detailed Explanation
NetApp ONTAP uses Logical Interfaces (LIFs) to provide network connectivity between cluster nodes. Each cluster LIF has a designated home node and home port, which represent its preferred operating location.
When a cluster interconnect switch fails, ONTAP can migrate affected cluster LIFs to alternative operational ports to maintain cluster communication.
After the failed switch is replaced and physical connectivity is restored, the LIFs may remain on their alternate ports if automatic reversion is disabled.
The auto-revert parameter determines whether ONTAP automatically returns a LIF to its designated home port when that port becomes healthy and available.
NetApp's official cluster networking documentation confirms that automatic reversion occurs when auto-revert is enabled and the home port is available.
NetApp Documentation
The administrator can enable this behavior using:
network interface modify -vserver Cluster -lif * -auto-revert true
Verify the configuration using:
network interface show -vserver Cluster -fields auto-revert,is-home
Option A: failover-policy determines eligible failover destinations rather than controlling automatic return to the home port.
Option C: allow-lb-migrate concerns load-balancing migration behavior, not automatic home-port reversion.
Option D: home-port specifies the preferred physical interface but does not enable automatic migration.
Therefore, B is correct.
Official NetApp References / Study Guide Topics:
NetApp Support Engineer ONTAP — ONTAP OS: cluster networking, LIF migration, automatic reversion, home ports, and switch failover recovery.
NetApp ONTAP — Cluster LIF Configuration and Auto-Revert
NetApp — Cluster Switch Replacement and LIF Recovery
=========================