JN0-336 Exam Dumps : Security, Specialist (JNCIS-SEC)

The correct answers are A and B. In an SRX chassis cluster, the cluster ID identifies the chassis cluster, and valid operational cluster IDs are nonzero values. Juniper’s chassis cluster command documentation states that the system uses the chassis cluster ID and node ID to apply the correct node-specific configuration, and the command writes the chassis cluster ID and node ID to EPROM. When the cluster ID is set to 0, clustering is disabled; therefore, the HA cluster configuration is effectively ignored because the device is no longer operating as a chassis-cluster member.

Option B is also correct because Juniper states that chassis cluster ID and node ID changes take effect only after the system is rebooted. That is why the operational command format includes the reboot behavior when setting cluster-id and node. Option C is wrong because node ID 0 is valid; it identifies node0 in the two-node cluster. Option D is wrong because SRX chassis clusters use node IDs 0 and 1 only; the 1–255 range applies to cluster IDs, not node IDs. Reference topics: HA Clustering, cluster ID, node ID, EPROM, chassis cluster enablement, node-specific configuration.

The correct answer is B. by using AppID results. Junos SSL proxy does not identify SSL/TLS sessions by assuming that encrypted traffic always uses TCP/443. That would be technically weak because SSL/TLS can run on nonstandard ports, and non-SSL applications can also use common HTTPS ports. Juniper’s SSL proxy documentation explains that SSL proxy works with application security services and that AppID is used in the encrypted-traffic inspection workflow. In earlier wording from Juniper AppSecure material, SSL proxy uses application identification services to determine whether a session is SSL encrypted; in current Junos documentation, SSL proxy and AppID are tightly linked so encrypted sessions can be identified, decrypted, inspected, and then re-encrypted for enforcement.

Option A is wrong because the URL is inside the HTTP payload, and in HTTPS much of the meaningful HTTP content is encrypted before SSL proxy inspection occurs. Option C is wrong because destination port is only a rough hint, not a reliable detection method. Option D is wrong because certificates are used in the SSL/TLS handshake and proxy trust model, but the service’s traffic classification relies on AppID results, not merely reading the server certificate. Reference topics: SSL Proxy, AppID, encrypted session detection, SSL/TLS inspection, application security services.

The correct answers are C and D. Once the SSL proxy profile already exists, the SRX still needs a security policy that matches the SSL/TLS traffic and applies the SSL proxy profile as an application service. Juniper’s SSL proxy configuration procedure explicitly shows creating the security policy match criteria and then applying the SSL proxy profile with then permit application-services ssl-proxy profile-name. It also states that SSL forward and reverse proxy require the profile to be configured at the firewall rule level.

Option D is correct because SSL proxy is not an end goal by itself; it decrypts SSL/TLS traffic so Layer 7 security services can inspect it. Juniper states that decrypted SSL traffic is available for security services and provides examples where the SSL proxy profile and a Content Security/UTM policy are both attached to the same security policy. Option A is wrong because host-inbound-traffic HTTPS controls HTTPS access to the SRX itself, not transit SSL proxy inspection. Option B is wrong because SSL proxy profiles are not referenced under a security zone for this function; they are applied under the matching security policy. Reference topics: SSL Proxy, SSL proxy profile, security policy application-services, Layer 7 inspection, UTM/IDP/ATP integration.