H35-480_V3.0 Exam Dumps : HCIA-5G-RAN V3.0 Exam

The X2 interface is a signaling interface used in LTE networks to interconnect two eNodeBs (LTE base stations) to support handover and other functions. In the inter-site DC solution, the X2 interface can also be used to implement the transmission interconnection between the LTE and NR sites.

In order to ensure smooth handover and service continuity between the LTE and NR sites, it is necessary to meet the requirement of low transmission delay, which is typically <20ms. This low delay requirement is important to ensure that the handover can be completed quickly and without interruption to the ongoing service.

According to the Huawei SA Networking Product Design Guide ( the downlink data split modes supported on the gNodeB side in the 5G NSA Option 3x architecture are A. MCGONLY: only split to the MCG and D. SCGANDMCG: dynamic data split. The MCGONLY mode is used when all the UE data must be sent to the same MCG, while the SCGANDMCG: dynamic data split mode is used when the data is split between multiple SCGs and MCGs.

The maximum number of PCIs (Physical Cell Identifiers) supported by a 5G network is 1008. This is specified in 3GPP 5G standard TS 38.211, which states that the maximum number of PCIs that a 5G network can support is 1008.

In 5G, each cell is assigned a unique identifier called the PCI (Physical Cell Identity). The PCI is used to identify the cell and its system information, and it is used for various purposes such as cell selection, handover, and interference management.

According to 3GPP specifications, the maximum number of PCIs that can be supported by a 5G network is 1008, which allows for a large number of cells to be deployed in a network. However, the actual number of PCIs used in a network will depend on the specific deployment scenario, the network architecture, and the capacity requirements of the network.