H13-629_V2.5 Exam Dumps : HCIE-Storage (Written) v2.5

5 devices TOE NIC A0, B1, and A0, B3 inserted into the PCIe slot will not affect the system. Deployment will not affect the network bandwidth, so it cannot be adjusted.

The signal cables are long and need to be strapped to the cabinet or placed on the bottom tray.

Label NODE 01 A0-0 The signal cable is inserted in the network port A0-1. The signal cable labeled NODE01 B3-1 is inserted in the network position B3-0, due to the same network card two network port peer, you can place the wrong line, you cannot adjust.

CE6850 switch connected to two stacked copper cables, one of which is needed to post-cold more cold, because it does not affect the network interoperability. You can base this software debugging.

In the scenario where the actual RPO indicator requires zero, you can choose to synchronize remote replication.

Synchronous remote replication can be used to map the main and secondary storage of the two sets of LUN mapping to the host to create a scenario volume.

Synchronous remote replication on the remote disaster recovery can be well done.

Because synchronous remote replication does not use snapshots, after synchronous remote replication is interrupted abnormally, the data on the primary LUN needs to be resumed in reply.Start synchronization to the slave site.

Stop the current production business, delete the host mapping.

Adding the remote device to the original production side array.

With the disaster recovery array as the master LUN and the original production array as the slave LUN, create the remote replication relationship between the DR and the production end and wait for the initial synchronization to be completed.

Make an incremental synchronization.

Delete the original production array consistency group.