Labour Day Special - Limited Time 65% Discount Offer - Ends in 0d 00h 00m 00s - Coupon code: top65certs

Vce 300-510 Questions Latest

Page: 8 / 16
Total 214 questions

Implementing Cisco Service Provider Advanced Routing Solutions (SPRI) Questions and Answers

Question 29

Refer to the exhibit A network engineer installed a new router (router 3) at the regional hub running MPLS services for scalability Router 3 is connected to the 10.44 4.0,'24. 10.44 5.024. 10 44.6.0/24. and 10 44 7 0/24 subnets The new router has been configured for OSPF area 2. and it is advertising the four connected networks. The engineer noticed that the same networks are listed as interarea summary routes, and they are being flooded into each area on the area borders Which action resolves the issue?

Options:

A.

On router 3, configure an access list to filter the networks.

B.

On router 2, configure a route map to filter the networks.

C.

Under the OSPF configuration on router 3. add area 2 range 10.44.4.0 255.255.252.0.

D.

Under the OSPF configuration on router 2, add area 2 range 10.44.4.0 255.255.252.0.

Question 30

Which difference should be considered when intradomain or interdomain multicast routing is implemented?

Options:

A.

Interdomain multicast routing requires an IS-IS or OSPF neighbor relationship between the domains but intradomain multicast routing requires only BGP

B.

Interdomain multicast routing relies on PIM-DM and intradomain multicast routing relies on PIM-SM.

C.

interdomain multicast routing uses BIDR-PIM to establish neighbor relationships between AS and interdomain multicast routing uses MSDP

D.

A network uses intradomain multicast routing without interdomain routing but networks that use interdomain multicast routing must also apply intradomain routing

Question 31

Refer to the exhibit. Users at the branch office on R1 reported issue with an application at the home office on R4. While troubleshooting the issue, a network engineer determined that

  • The branch-office users can connect to the home office.
  • The IS-IS adjacencies between R1 and R2 and R1 and the branch office are up.
  • Traffic from R1 to the R2 10.20.1.0/24 network is moving normally.
  • The application at the home office is experiencing packet drops on the connection to the Branch, and R3 cannot reach the R1 172.16.10.0/24 network.

Which action resolves the issues?

Options:

A.

Redistribute static connected routes in IS-IS on router RI.

B.

Configure the IS-IS core instance on the RI GigabitEthernet0/3 interface.

C.

Redistribute static connected routes in IS-IS on router R4.

D.

Configure the IS-IS core instance on the R2 GigabitEthernet0/1 interface.

Question 32

Refer to the exhibit.

The UserA device fails to recede IPTV streaming traffic from the source While debugging the issue a network engineer finds that routers RB and RC receive the multicast traffic normally RC receives subscription messages from UserA to join the IPTV stream Which action must the engineer lake on router RA to correct this problem?

Options:

A.

Configure ip pim ssm with ip igmp version 2 on interface GigabitEthernet 1/0.

B.

Remove the ip pim ssm default configuration and replace it with ip pim rp-address 10.10.1.3

C.

Change ip igmp version 2 to ip igmp version 3 on interface GigabitEthernet 1/0.

D.

Configure ip pim bidir-enable in global mode and add ip pim rp-address 10.10.10.3

Page: 8 / 16
Total 214 questions