CertsTopics Logo

Labour Day Special - Limited Time 65% Discount Offer - Ends in 0d 00h 00m 00s - Coupon code: top65certs

Cisco 300-510 Questions Answers

Page: 10 / 16
Total 214 questions
Get 300-510 Full Access Download 300-510 PDF

Implementing Cisco Service Provider Advanced Routing Solutions (SPRI) Questions and Answers

Question 37

Refer to the exhibit.

What is the relationship between Router 1 and Router 2?

Options:

A.

Router 1 centrally learns the topology of the network to aid in SR-TE path selection, and Router 2 is a node that feeds Router 1 topology information.

B.

Router 1 and Router 2 are participating in SR-TE tunnels and are both head-end routers.

C.

Router 1 and Router 2 centrally learn the topology of the network to aid in SR-TE path selection for peers.

D.

Router 2 is the head-end router in an SR-TE tunnel, and it is learning topology of the network from the PCE enabled on Router 1.

Question 38

Refer to the exhibit.

Which task must you perform on interface g1/0/0 to complete the SSM implementation?

Options:

A.

configure OSPFv3

B.

enable CDP

C.

disable IGMP

D.

configure IGMPv3

Question 39

Refer to the exhibit. An engineering team implemented IS-IS on the network, with several different areas. Recently, router R6 in area 3 has been experiencing excessive CPU usage. To reduce the load, a network engineer implemented route summarization on R2 However. R6 is still receiving the full routes from all routers. Which action must the engineer take to resolve the excessive CPU usage?

Options:

A.

Configure routers R3 and R5 to send summary routes to R6.

B.

Configure the Level 2 router R6 to manage summarization for the network

C.

Configure router R1 to send only the default route to R2 and R4.

D.

Configure all routers as Level 1/2 routers so that route summarization functions throughout the network

Question 40

Refer to the exhibit. An engineer is troubleshooting an issue with this network and notices that prefixes from R3 are missing on the R1 routing table Due to repeated ASN when the 10 0 0 0'8 prefix from R3 arrives at R1, BGP automatically rejects it There is no prefix-list on R1 which blocks the traffic from R3 What should the engineer do to fix the problem so that BGP allows that prefix on R1?

Options:

A.

Configure R2 as a route reflector client of R1.

B.

Configure the allowas-in command on R1.

C.

Configure the next-hop-self command on R2.

D.

Configure identical confederation ASNs on R1 and R2.

Page: 10 / 16
Total 214 questions
Get 300-510 Full Access Download 300-510 PDF