Legit 300-510 Exam Download

Implementing Cisco Service Provider Advanced Routing Solutions (SPRI) Questions and Answers

Question 45

Which two differences should be considered when deciding whether to implement to implement routing policies or route maps? (Choose two.)

Options:

Sequences are added after implementing a route map, but routing policies must be reconfigured when change is needed.

Route maps are implemented using hierarchical policies, but routing policies must be implemented sequentially.

Route maps require an explicit deny at the end of the sequence, but routing policies have an implicit deny at the end of the program.

Route policies require sequence numbers, but route maps are implemented without sequencing.

Route maps are supported in Cisco 10S Software and routing policies are supported in Cisco IOS XR Software.

Question 46

Refer io the exhibit.

While applying the configurations on two routers an engineer notices that OSPF adjacency Between them remains down Through the ping test the engineer confirmed that both me routers have Layer 3 reachability between them Which action should me engineer take to make the adjacencies to full?

Options:

Enter the command ip ospf authentication in R2 interface

Enable OSPF just inside the router OSPF process not in the interfaces of any router

Delete the area 0 authentication message-digest command from the OSPF process in R1

Delete the area 0 authentication message-digest command from the OSPF process in R2

Question 47

Refer to the exhibit.

There is a connectivity issue between Customer-1 and Customer-2 File servers between the customers cannot send critical data R3 routes are missing from the routing table on the Customer-1 router All interlaces on Customer-1 are up Which configuration must be applied to router R2 to correct the problem?

Options:

Option A

Option B

Option C

Option D

Question 48

Refer to the exhibit.

An administrator is troubleshooting network issues on a customer’s network PE1 cannot form an LDP relationship with PE2 using LDP ID 192 168.1.1. Due to this connectivity issue, the customer’s routes behind both PE routers cannot be exchanged. Which action must the administrator take to correct the problem?

Options:

Configure PE2 to automatically select its own LDP router ID with 192.168.1.1.

Create a targeted LDP session on PE2 to override the missing routing table entry on PEL

Configure PE1 with a static route to 192 168.1.1.

Enable LDP session protection on the link that P1 uses as the next hop to PE2.

Labour Day Special - Limited Time 65% Discount Offer - Ends in 0d 00h 00m 00s - Coupon code: top65certs

Implementing Cisco Service Provider Advanced Routing Solutions (SPRI) Questions and Answers

Options:

Answer:

Options:

Answer:

Options:

Answer:

Options:

Answer: