Pass 300-425 Exam Guide

When configured with priority 1, the access point is assigned with the highest priority level and it is marked as critical. This access point fails over before other access points with the lower priority when there is primary controller failure.

When configured with priority 4, the access point is assigned with the highest priority level and it is marked as critical. This access point fails over before other access points with the lower priority when there is primary controller failure.

When configured with priority 4, the access point is assigned with the lowest priority level and it is marked as low. This access point fails over after other access points with the higher priority when there is primary controller failure.

When configured with priority 1, the access point is assigned with the medium priority level and it is marked as medium. This access point fails over after other access points with the higher priority when there is primary controller failure.

Packets are always sent out on the same port they are received on.

All interface traffic passes as long as one port is up.

The same port has multiple untagged dynamic interfaces.

Interface connection to two separate nonstacked switches is available.

Full bandwidth of all links is available.

Ports are grouped into multiple LAGs.

Add additional APs to all the comers of the site.

Add more APs than indicated from the site survey spread across all areas.

Add an additional AP in the middle of the dense area.

Run the site survey using -57d Bm as a threshold.

30 m

40 m

70 m

90 m