CertsTopics Logo

Weekend Sale Special - Limited Time 65% Discount Offer - Ends in 0d 00h 00m 00s - Coupon code: top65certs

CCNP Enterprise 300-425 Passing Score

Page: 7 / 15
Total 196 questions
Get 300-425 Full Access Download 300-425 PDF

Designing Cisco Enterprise Wireless Networks (ENWLSD) Questions and Answers

Question 25

An engineer has successfully configured high availability and SSO using two Cisco 5508 Wireless LAN Controllers. The engineer can access the Active Primary WLC, but the Secondary Standby WLC is not accessible. Which two methods allow access to the standby unit? (Choose two.)

Options:

A.

via the console connection

B.

SSH to the redundancy management interface of the primary WLC

C.

SSH to the service port interface

D.

SSH to the virtual interface of the secondary WLC

E.

SSH to the management interface of the primary WLC

Question 26

A customer celled with a requirement that internal clients must be on different subnets depending on the building they are in, AH access points are operating in local mode and will not be modified, and this is a single controller solution. Which design approach creates the desired result?

Options:

A.

Create an SSID, place it to the desired VLAN under WLANs, and configure 802 lx in ISE to assign the correct VLAN based on the SSID from which the client is authenticating.

B.

Create FlexConnecI groups, place the access points in. and sat the correct VLAN to SSID mapping based on location.

C.

Create AP groups for each desired location, map the correct VLANs to the internal SSID, and add the access points for that location.

D.

Create mobility anchors for the SSID, and on the controller under the internal SSID. create a foreign map to the desired VLAN based on location.

Question 27

Refer to the exhibit.

A WLC SSO pair is set up. Which failure scenario causes a split-brain scenario?

Options:

A.

RP is down.

B.

Two distribution ports on the active WLC are down.

C.

VSL is down.

D.

One distribution port on the active WLC is down.

Question 28

An enterprise network administrator is asked to set up an experimental WLAN for a collaboration project with a local service provider. The WLAN must be anchored to a WLC in the service provider data center using legacy mobility mode. After the configurations are completed on the WLCs and the firewalls in the path, the data path mobility tunnel is failing to come up. What should be performed by the administrator to debug the issue?

Options:

A.

Establish a Telnet connection from a local PC to the firewall on port 97.

B.

Use the mapping command on the WLC.

C.

Establish a Telnet connection from a local PC to the firewall on port 16666.

D.

Use the mapping command on the WLC.

Page: 7 / 15
Total 196 questions
Get 300-425 Full Access Download 300-425 PDF