New Release CWNA-109 CWNA Certification Questions

 This is because the passphrase for WPA2-Personal is case-sensitive and must match exactly on both the AP and the client. If the passphrase is entered incorrectly on the client, the client will not be able to authenticate with the AP and connect to the network. The AP that covers the problem area is not likely to require a firmware update, fail, or be improperly configured, as it is online and works with other clients that have the correct passphrase. To troubleshoot this issue, you can check the passphrase settings on the clients and make sure they match with the AP. You can also try to reconnect the clients to the network or reboot them if necessary. For more information on how to configure WPA2-Personal on your router

The CWNA Official Study Guide (CWNA-109), Chapter 8: Troubleshooting and Spectrum Analysis, explains that hidden node problems occur when two or more client stations cannot hear each other but can both communicate with the same access point. This leads to collisions at the AP because the clients transmit simultaneously without sensing each other’s signals.

“Hidden node problems can often be identified in a protocol analyzer by observing excessive retransmissions from specific client stations. These retransmissions occur because the station’s frames are not acknowledged due to collisions caused by other stations that the transmitter cannot hear.”

— CWNA-108 Study Guide, Chapter 8, Hidden Node Problem Analysis, p. 393–395

Therefore, when analyzing for a hidden node issue, you will typically observe:

Retransmitted frames from multiple STAs.

Higher retry counts for affected stations compared to others.

Hence, the correct answer is C. Retransmitted frames from multiple STAs with higher retry counts than other STAs.

The BSSID (Basic Service Set Identifier) is typically mapped to an AP’s MAC address if a single BSS is implemented. The BSSID is a unique identifier that distinguishes one BSS from another within the same RF medium. It is usually derived from the MAC address of the AP’s radio interface, but it can also be manually configured or randomly generated by some vendors. The BSSID is used by client stations to associate with an AP and to send and receive frames within a BSS. References: , Chapter 1, page 24; , Section 1.2

Wireless bridging is a WLAN technology role that allows two or more networks to be connected wirelessly over a distance. A wireless bridge consists of two or more APs that are configured to operate in bridge mode and use directional antennas to establish a point-to-point or point-to-multipoint link. Wireless bridging can support high data rates and is suitable for scenarios where running cables is impractical or expensive. To create a wireless link between two buildings on a single campus that supports at least 150 Mbps data rates, wireless bridging is an appropriate solution678. References: CWNA-109 Study Guide, Chapter 6: Wireless LAN Devices and Topologies, page 271; CWNA-109 Study Guide, Chapter 6: Wireless LAN Devices and Topologies, page 265; Wi-Fi Wireless Bridging Explained.