HCIE-Datacom H12-891_V1.0 Updated Exam

BGP EVPN in VXLAN Tunneling

✅ A. MP_REACH_NLRI is used to carry routing information.

MP_REACH_NLRI (Multiprotocol Reachable Network Layer Reachability Information) is used in BGP updates to carry VXLAN reachability information.

✅ B. Several BGP EVPN routes are defined through BGP extension.

BGP EVPN introduces multiple route types, such as Type 2 (MAC/IP Advertisement), Type 3 (Inclusive Multicast), and Type 5 (IP Prefix Advertisement).

✅ D. MP_REACH_NLRI is used to carry the RT.

RT (Route Target) defines route import/export policies in VPN environments.

MP_REACH_NLRI carries the RT attribute in BGP EVPN updates.

❌ Incorrect Answer:

❌ C. MP_REACH_NLRI is used to carry the RD.

Wrong! The Route Distinguisher (RD) is carried inside BGP attributes, but not in MP_REACH_NLRI.

Reference from Huawei HCIE-Datacom Documentation:

Huawei VXLAN BGP EVPN Configuration Guide – BGP EVPN Route Types

HCIE-Datacom Training Material – VXLAN Dynamic Tunnel Establishment

OSPFv3 (used for IPv6) uses IPv6 multicast addresses for communication between routers:

FF02::5 — All OSPF routers.

FF02::6 — All OSPF Designated Routers (DRs) and Backup Designated Routers (BDRs).

FF08::x — These are used for organization-local scope, which is not applicable to standard OSPFv3 operation.

Therefore:

C. All OSPF routers use FF02::5 — Correct

D. The DR uses FF02::6 — Correct

A and B (FF08::x) — Incorrect. These addresses are not used by OSPFv3 in this context.

Correct answers: C and D

In MPLS LDP, there are two types of sessions:

Direct LDP sessions: Established between directly connected LSRs using LDP Hellos over a link.

Remote LDP sessions (also called targeted LDP sessions): Established between non-directly connected LSRs. These require manual configuration of the remote peer.

In this scenario, SWA and SWC are not directly connected, so a remote (targeted) LDP session must be set up.

For a remote LDP session:

You must configure the remote peer using the command:

[SWA-MPLS-LDP] targeted-peer x.x.x.x

Where x.x.x.x is the LSR ID of SWC (33.3.3.3 in this case).

The current configuration does not include this required step.

Thus, the correct statement is:

D. You need to create a remote peer and specify an LSR ID for the remote peer.

Before performing a network cutover (migration or upgrade), it is essential to collect baseline data to ensure that services operate normally before and after the change.

Importance of Pre-Cutover Information Collection:

Identifies Network Baseline – Helps compare pre-cutover and post-cutover performance.

Detects Hidden Issues – Ensures that no existing network issues interfere with the cutover process.

Prevents Service Interruptions – Ensures all dependent services are accounted for.

Provides Rollback Plan – If issues arise, administrators can restore previous configurations.

Reference from Huawei HCIE-Datacom Documentation:

Huawei Network Change Management Guide – Pre-Cutover & Post-Cutover Best Practices

HCIE-Datacom Training Material – Service Assurance & Risk Analysis