What is a valid status of an endpoint attribute during the device registration process?
An engineer wants to use certificate authentication for endpoints that connect to a wired network integrated with Cisco ISE. The engineer needs to define the certificate field used as the principal username. Which component would be needed to complete the configuration?
An administrator enables the profiling service for Cisco ISE to use for authorization policies while in closed mode. When the endpoints connect, they receive limited access so that the profiling probes can gather information and Cisco ISE can assign the correct profiles. They are using the default values within Cisco ISE. but the devices do not change their access due to the new profile. What is the problem'?
Refer to the exhibit.
An engineer is creating a new TACACS* command set and cannot use any show commands after togging into the device with this command set authorization Which configuration is causing this issue?
Copyright © 2021-2025 CertsTopics. All Rights Reserved
