1z0-820 Exam Dumps : Upgrade to Oracle Solaris 11 System Administrator

The ipmpstat command concisely displays information about the IPMP subsystem. It supports five different output modes, each of which provides a different view of the IPMP subsystem (address, group, interface, probe, and target), described below.

-i

Display IP interface information (“interface” output mode).

Interface Mode

Interface mode displays the state of all IP interfaces that are tracked by in.mpathd on the system. The following output field is one of the supported:

FLAGS

Assorted information about the IP interface:

i

(D) Unusable due to being INACTIVE.

s

Marked STANDBY.

m

(E) Nominated to send/receive IPv4 multicast for its IPMP group.

b

Nominated to send/receive IPv4 broadcast for its IPMP group.

M

Nominated to send/receive IPv6 multicast for its IPMP group.

d

Unusable due to being down.

h

Unusable due to being brought OFFLINE by in.mpathd because of a duplicate hardware address.

A: Conditional and system locations can be manually

activated, which means that the location remains active until explicitly disabled.

D: A location comprises certain elements of a network configuration, for example a name service

and firewall settings, that are applied together, when required. You can create multiple locations

for various uses. For example, one location can be used when you are connected at the office by

using the company intranet. Another location can be used at home when you are connected to

the public Internet by using a wireless access point. Locations can be activated manually or

automatically, according to environmental conditions, such as the IP address that is obtained

by a network connection.

The zoneadm command is the primary tool used to install and administer non-global zones. Operations using the zoneadm command must be run from the global zone on the target system.

How to Install the solaris10 Branded Zone

A configured solaris10 branded zone is installed by using the zoneadm command with the install subcommand.

Example: global# zoneadm -z s10-zone install -a /net/machine_name/s10-system.flar –u