Netskope NSK200 Exam With Confidence Using Practice Dumps

Two reasons for the message “Disabled due to error” when hovering the mouse over the Netskope client icon are A. The client service is manually stopped and C. The client health check has failed. The client service is a background process that runs the Netskope client on the user’s device and communicates with the Netskope cloud. If the client service is manually stopped by the user or by another program, the Netskope client will be disabled and show a red dot on the icon1. The client health check is a feature that monitors the status of the Netskope client and performs self-repair actions if any issues are detected. If the client health check has failed, it means that the Netskope client has encountered a critical error that cannot be fixed automatically, such as corrupted files or registry entries. In this case, the Netskope client will be disabled and show a red dot on the icon2. Therefore, options A and C are correct and the other options are incorrect. References: Troubleshooting Netskope Client - Netskope Knowledge Portal, Client Health Check - Netskope Knowledge Portal

Netskope’s GRE tunneling supports only web traffic, which means ICMP traffic (ping) is not supported for hosts behind the Netskope gateway. You may, however, ping the probe IP provided by Netskope to test connectivity, as this IP is designated for diagnostics​​.

To determine proper policy ordering for Netskope Real-time Protection policies, you need to follow these two statements: B. You do not need to create an “allow all” Web Access policy at the bottom. D. You must place high-risk block policies at the top. These statements are based on the best practices for policy ordering recommended by Netskope3. An “allow all” Web Access policy at the bottom is not necessary because any traffic that does not match any policy will be allowed by default. However, you can create a “monitor all” Web Access policy at the bottom if you want to log all the traffic that is not matched by any other policy4. High-risk block policies at the top are important because they prevent any traffic that poses a serious threat or violates a critical compliance standard from reaching its destination. These policies should have higher priority than other policies that may allow or modify the traffic5. Therefore, options B and D are correct and the other options are incorrect. References: Real-time Protection Policies - Netskope Knowledge Portal, Create a Real-time Protection Policy for Web Categories - Netskope Knowledge Portal, Best Practices: Real-time Protection Policies (1 of 2) - Netskope