Sure Pass Exam API-SIEE PDF

The correct answer isB. In large motor inspection practice underAPI 541, asoft footcheck is performed to confirm that all motor mounting feet sit properly on the base and that tightening or loosening the hold-down bolts does not distort the motor frame. The accepted method is to first have the mounting bolts tightened, then place adial indicator verticallyat the foot,zero the indicator, and observe the movement when the bolt torque isrelieved or loosened. If the foot lifts or the frame shifts beyond the permitted tolerance, the condition indicates soft foot and must be corrected before the mechanical running test.

This matters because soft foot can introduce frame strain, misalignment, elevated vibration, bearing loading, and unreliable mechanical test results. In source inspection, the purpose is not merely to verify bolt tightness or visible fit-up, but to confirm that the machine is mounted without distortion under actual installed clamping conditions. Option A may reveal a gap but does not fully assess frame movement under bolt load. Option C reverses the usual verification sequence. Option D is inadequate because torque and visual appearance alone do not confirm absence of soft foot.

The correct answer isD. In ANSI transformer standards under theC57.12 series, the impulse withstand capability assigned to transformer line terminals is expressed in terms of theBasic Lightning Impulse Insulation Level, commonly calledBIL. This value represents the crest value of a standard lightning impulse wave that the transformer insulation system must be able to withstand without failure. It is used to establish the insulation coordination of the transformer and to verify that external terminals and associated winding insulation can tolerate expected surge conditions on the system.

From a source inspection perspective, this requirement is important because the inspector must verify that the transformer design data, nameplate information, and test documentation match the specified insulation class and impulse withstand ratings. The BIL rating is a fundamental acceptance characteristic for transformers because it confirms the equipment’s ability to survive transient overvoltage events such as lightning surges.Switching impulseis a different category used more commonly on higher voltage equipment under certain system conditions.Chopped waveis a special test application, not the primary maximum insulation level designation asked here. Therefore, the correct maximum value is theBasic Lightning Impulse Insulation Level.

The correct answer isC, Voltmeter. A voltmeter is the instrument specifically used to measure theelectrical potential difference, or voltage, between two points in a circuit. In electrical inspection and testing, voltage measurement is fundamental for verifying whether circuits, terminals, control panels, and equipment are energized at the correct values required by the design documents and equipment ratings. During source inspection and quality surveillance, understanding the correct use of test instruments is important because inspectors may review or witness electrical tests that confirm compliance with specifications and safe operating conditions.

The other options are not correct for this purpose. Anamp metermeasures current flow, not voltage. AWheatstone bridgeis primarily used for precise resistance measurement. Apotentiometeris generally a variable resistor or a device used in circuit adjustment and comparison methods, but it is not the standard instrument identified for routine measurement of potential difference in a circuit.

Therefore, when the question asks which instrument measures voltage between two points, the technically correct and standard answer isvoltmeter.