PDF 352-011 Study Guide

Cisco Certified Design Expert Practical Exam Questions and Answers

Question 5

How must queue sizes be designed to ensure that an application functions correctly?

Options:

The default queue sizes are good for any deployment

Each individual device queuing delay in chain must be less than or equal to the application required delay

The queuing delay on every device in chain must be exactly the same

The sum of the queuing delay of all devices in chain must be less than or equal to the application required delay

Question 6

You are presented with requirements to design a development, testing and production environments. These environment should communicate with each other, yet they should be kept as separate failure domains. Which routing protocol should be configured on the links between the networks to support the design requirements?

Options:

OSPF

EIGRP

IS-IS

BGP

Question 7

In a VPLS design solution, which situation indicates that BGP must be used instead of LDP in the control plane?

Options:

MAC address learning scales better through BGP

BGP supports VPLS interworking

Pseudowire configuration overhead is reduced

There are no full-mesh pseudowire due to the route reflection feature of BGP

Question 8

Refer to the exhibit.

As part of a redesign project, you must predict multicast behavior. What is the resultant multicast traffic receiving on the shared tree( , G), if it is received on the LHR interface indicated?

Options:

It is dropped due to an unsuccessful RPF check against the multicast receiver

It is switched due to a successful RPF check against the routing table

It is switched given that no RPF check is performed

It is dropped due to an unsuccessful RPF check against the multicast source

Labour Day Special - Limited Time 65% Discount Offer - Ends in 0d 00h 00m 00s - Coupon code: top65certs

Cisco Certified Design Expert Practical Exam Questions and Answers

Options:

Answer:

Options:

Answer:

Options:

Answer:

Options:

Answer: