All H12-711_V4.0 Test Inside Huawei Questions

On Huawei firewalls, traffic direction is determined according to the priority of security zones . When traffic moves from a low-priority zone to a high-priority zone , that direction is called Inbound . For example, traffic going from the Untrust zone to the Trust zone is considered inbound because Untrust has a lower security priority than Trust.

By contrast, traffic moving from a high-priority zone to a low-priority zone is called Outbound . A common example is internal users in the Trust zone accessing resources on the Internet in the Untrust zone. This zone-priority concept is important because firewall security policies, packet filtering behavior, and session control are all evaluated according to the source zone and destination zone.

Understanding inbound and outbound directions is essential when configuring interzone security policies. Administrators must know whether traffic is flowing from low to high priority or high to low priority in order to apply the correct permit, deny, NAT, and inspection rules. Since the question specifically asks for the direction from a low-priority zone to a high-priority zone, the correct answer is Inbound .

This statement is TRUE . A DMZ is a special security zone used to place servers that must provide services to external users while still being isolated from the internal trusted network. Typical examples include WWW servers, FTP servers, mail servers, and DNS servers . These systems need to be accessible from outside networks such as the Internet, but placing them directly inside the internal network would increase security risk.

The purpose of the DMZ is to create a buffer area between the Untrust zone and the Trust zone. External users can be allowed to access the public-facing servers in the DMZ according to security policies, while access from the DMZ to the internal network can be more strictly restricted. This design helps reduce the chance that an attacker who compromises a public server can directly reach sensitive internal systems.

On Huawei firewalls, the DMZ is one of the default security zones and is specifically intended for such semi-public service devices. Therefore, devices that provide external network services, such as WWW and FTP servers, can correctly be deployed in the DMZ .

Huawei firewalls support creating multiple sub-interfaces on a single physical interface such as GE0/0/1 so that one physical link can carry traffic for multiple VLANs. Each sub-interface is configured with an 802.1Q VLAN tag, which allows it to logically represent one VLAN or one Layer 3 gateway interface for that VLAN. This design is commonly used when the firewall connects to a switch through a trunk and needs to provide routing and security control for several VLANs simultaneously.

The statement is incorrect because sub-interfaces can be added to security zones. A security zone is a logical security domain used for policy enforcement, and Huawei firewalls allow both physical interfaces and logical interfaces (including VLAN sub-interfaces) to be assigned to zones. This is essential for implementing interzone security policies between VLANs. For example, if two VLANs are mapped to two different sub-interfaces, placing each sub-interface into a different zone allows the firewall to apply access control, inspection profiles, and NAT based on zone-to-zone rules. Therefore, the claim that sub-interfaces cannot be added to security zones is false.

Explanation From HCIA-Security documents:

This scenario states two key conditions: (1) there are only a small number of users accessing the Internet, and (2) the number of available public IP addresses is equal to the number of concurrent Internet users. That means the organization has enough public addresses to assign a dedicated public IP to each internal user at the same time. In such a case, the most suitable NAT type is NAT No-PAT, which is also commonly understood as traditional one-to-one address translation (no port translation). The internal source IP is translated to a unique public source IP, and the transport-layer port number is not multiplexed to share a single public IP among many users.

By contrast, NAPT and Easy IP are used when public addresses are scarce, because they translate multiple internal users to one or a few public IP addresses by also translating port numbers (PAT). 3-tuple NAT is a more specific translation method involving matching/translation with additional parameters, but it is not the standard choice described by the given “equal number of public IPs and concurrent users” condition. Therefore, NAT No-PAT is correct.