PDF NCP-MCI-6.10 Study Guide

When synchronous replication has been configured and a planned failover is required for datacenter maintenance, Nutanix recommends performing aplanned failoverto ensure data consistency and a clean transition of services.

From theNutanix Enterprise Cloud Administration (ECA)course materials:

“A planned failover ensures that data replication is complete and consistent between the primary and standby sites before the workload is migrated. This prevents data loss and ensures seamless recovery.”

Additionally:

“A planned failover can be initiated either from the primary site or from the standby site. This provides flexibility depending on operational preferences and site availability during maintenance windows.”

“Unplanned failovers should only be used in the event of unexpected site outages or catastrophic failures, as they may involve data loss or incomplete synchronization.”

Therefore, the correct approaches are to conduct a planned failover either from the standby site (B) or from the primary site (D). This ensures seamless workload transition during the datacenter maintenance event.

Understanding the Exhibit & Memory Allocation

Thehost has 128GB of physical RAM.

Thecurrent memory allocationacrossthree VMs (VM1, VM2, VM3) is 128GB, but only92GB is actually utilized.

This means there is36GB of unutilized memory available for allocation.

Step-by-Step Breakdown

Existing Memory Usage Before Adding VM4

Total Physical RAM:128GB

Used by running VMs (VM1, VM2, VM3):92GB

Unutilized Memory Available:36GB

After Creating and Running VM4

VM4 is allocatedmemory but only utilizes 28GB.

The table does not show VM4’s allocated RAM, but assuming it was given a reasonable allocation, it must have been taken from the36GB unutilized memory pool.

IfVM4 uses 28GB, theremaining unutilized memory is now (36GB - 28GB) = 8GB.

Maximum Memory Allocation for VM5

Sinceonly 8GB remains unutilized, the maximum memory VM5 can be allocated while still allowing it to power on is8GB.

Evaluating the Answer Choices

(A) 4GB❌(Incorrect)

More memory (8GB) is available, so limiting to 4GB is unnecessary.

(B) 8GB✅(Correct)

Theremaining unutilized memory after VM4 is 8GB, so VM5 can be allocated up to8GBwhile ensuring it can power on.

(C) 16GB❌(Incorrect)

Only8GB is left, so 16GB isnot possible.

(D) 32GB❌(Incorrect)

There isnot enough unutilized memoryto allocate 32GB.

Key Concept: Nutanix Memory Overcommit

Nutanix AHV supportsmemory overcommit, meaning VMs can be allocated more memory than physically available usingmemory ballooning and swapping.

However,to power on VM5 without impacting performance, it must fit within the available unutilized memory, which is8GB.

In a 12-node FT2 cluster, onlyonenode can be placed into maintenance mode at a time. This ensures that the cluster maintains data redundancy and protection (FT2 indicates 2-failure tolerance).

From theNutanix Enterprise Cloud Administration (ECA)course materials:

“For FT2 clusters, a maximum of one node can be placed in maintenance mode at a time to ensure the cluster’s ability to tolerate failures and maintain quorum.”