Palo Alto Certifications and Accreditations PCNSE Dumps PDF

If the DNS response matches the Original Destination Address in the rule, translate the DNS response using the same translation the rule uses. For example, if the rule translates IP address 1.1.1.10 to 192.168.1.10, the firewall rewrites a DNS response of 1.1.1.10 to 192.168.1.10.

These are the two links that can be used to configure an active/active high availability pair. An active/active high availability pair consists of two firewalls that are both active and share the traffic load between them1. To configure an active/active high availability pair, the following links are required2:

HA1: This is the control link that is used for exchanging heartbeat messages and configuration synchronization between the firewalls. It can be a dedicated interface or a subinterface. It can also have a backup link for redundancy.

HA2: This is the data link that is used for forwarding sessions from one firewall to another in case of failover or load balancing. It can be a dedicated interface or a subinterface. It can also have a backup link for redundancy.

HA3: This is the session owner synchronization link that is used for synchronizing session information between the firewalls in different virtual systems. It can be a dedicated interface or a subinterface. It is only required for active/active high availability pairs, not for active/passive pairs.

"Log redundancy is available only if each Log Collector has the same number of logging disks." (Recommended) Enable log redundancy across collectors if you are adding multiple Log Collectors to a single Collector group. Redundancy ensures that no logs are lost if any one Log Collector becomes unavailable. Each log will have two copies and each copy will reside on a different Log Collector. For example, if you have two Log Collectors in the collector group the log is written to both Log Collectors. Enabling redundancy creates more logs and therefore requires more storage capacity, reducing storage capability in half. When a Collector Group runs out of space, it deletes older logs. Redundancy also doubles the log processing traffic in a Collector Group, which reduces its maximum logging rate by half, as each Log Collector must distribute a copy of each log it receives.