Summer Special - Limited Time 65% Discount Offer - Ends in 0d 00h 00m 00s - Coupon code: top65certs

Full Access Fortinet FCP_FGT_AD-7.6 Tutorials

FortiGate 7.6 Administrator FCP_FGT_AD-7.6 Questions and Answers

Question 9

A network administrator enabled antivirus and selected an SSL inspection profile on a firewall policy.

When downloading an EICAR test file through HTTP, FortiGate detects the virus and blocks the file. When downloading the same file through HTTPS, FortiGate does not detect the virus and does not block the file, allowing it to be downloaded.

The administrator confirms that the traffic matches the configured firewall policy.

What are two reasons for the failed virus detection by FortiGate? (Choose two.)

Options:

A.

The selected SSL inspection profile has certificate inspection enabled.

B.

The website is exempted from SSL inspection.

C.

The El CAR test file exceeds the protocol options oversize limit.

D.

The browser does not trust the FortiGate self-signed CA certificate.

Question 10

An administrator wants to configure dead peer detection (DPD) on IPsec VPN for detecting dead tunnels. The requirement is that FortiGate sends DPD probes only when there is no inbound traffic.

Which DPD mode on FortiGate meets this requirement?

Options:

A.

Enabled

B.

On Idle

C.

Disabled

D.

On Demand

Question 11

FortiGate is operating in NAT mode and has two physical interfaces connected to the LAN and DMZ networks respectively.

Which two statements about the requirements of connected physical interfaces on FortiGate are true? (Choose two.)

Options:

A.

Both interfaces must have the interface role assigned.

B.

Both interfaces must have directly connected routes on the routing table.

C.

Both interfaces must have DHCP enabled and interfaces set to LAN and DMZ roles assigned.

D.

Both interfaces must have IP addresses assigned.

Question 12

Refer to the exhibits.

Based on the current HA status, an administrator updates the override and priority parameters on HQ-NGFW-1 and HQ-NGFW-2 as shown in the exhibit.

What would be the expected outcome in the HA cluster?

Options:

A.

HQ-NGFW-1 will synchronize the override disable setting with HQ-NGFW-2.

B.

HQ-NGFW-2 will take over as the primary because it has the override enable setting and higher priority than HQ-NGFW-1.

C.

HQ-NGFW-1 will remain the primary because HQ-NGFW-2 has lower priority.

D.

The HA cluster will become out of sync because the override setting must match on all HA members.